MX-3.com

that's a beautiful car. kinda iffy about the rust but I live in wisconsin so I know how it is

I'm slightly interested, but it will be awhile. I'm sure it will sell before, so good luck sir!

Mine leaks a little from the seals that the cv shafts go into. I need to replace them

I just used a little RTV for the time being

I'll have fun scraping that off soon :-p

http://www.youtube.com/watch?v=gC7JKw-vVjc

that's an older one. I'm currently replacing the IM, and trying to figure out why my rear caliper keeps sticking.

I might take a short vid tonight. It's still a POS, lol.

I picked up a millenia IM, with no throttle body as well. I'm going to be getting a millenia TB in about 2 weeks, can I run the K8 TB for the time being? (I know it probably sucks, but will it work?)

lol, I just took my manifold off too, and I kept having problems with the rear vent and that tiny screw on the drivers side. I jacked it up and looked at it from underneath to find out what was holding it in. my new IM didn't come with a rear vent pipe, so I'm going to just use a hose. What should I...

I have the same problem. I installed a stage 3 clutch and it shudders like hell if you try to engage it slowly.

I checked all my mounts, etc. Everything's fine, the clutch is just a little too much for street use I think.

It's an F1 Stage 3.

I bought my mx-3 when I was 18. I knew little about how to work on cars, but you inspired me. My tranny went out and my engine was running rough after I took it to a crappy mechanic to get my disty replaced. I know he broke it, but I can't prove it. I embarked on a KLZE adventure that was one of the...

Just so you know, it's going to end up costing you a lot more then you think. My advice would be to download the shop manual, print it out, and never stop reading it or referencing it on everything you do. And, as always, these guys are here to help. They've helped me 100 times where I was so frustr...

Both heads would have to be cracked, they are in

XXC
CXX (c=coolant, x=dry)

I'll look at it again tomorrow. It's very weird for it to be up there. I could just be dirty water too, its been super humid out and it's been sitting for a month.

Its verrry suspicious

its possible I spilled it because i did disconnect some coolant lines, but there aren't any signs of spillage, and its in very opposite ports.

I took off my intake manifold to put on a millenia IM..... and two of the ports have a tiny bit of coolant on the vavles. The car has been sitting for a month.

Is my head gasket destroyed? Should I start crying?

So I put my car on jackstands to get at most of the wiring to put covers on them. When I drove it afterwards I got a noise starting at 20mph and gets louder (constant noise) the faster I go. Could one of my rear brakes be touching or binding? All i can think of is that when i had the e brake on to j...

So, I made a socket. Made it really nice. I go to put it on the sensor, and i put the wire in the slot to get the socket on. Then then wire falls out. That's right, just falls out of the knock sensor. There is an inch of some sort of black tar covering up where this thing is supposed to connect on t...