MX-3.com

help i need a 1.6 head with the casting #541 stamped on it thanx if in canada send e-mail to shanerboy_77@hotmail.com

This is the best way to get buy with blue head lights! buy a set of the cool blue lights open one of them and get the paper out of the pack call the 1-800 # tell them that you need the paper work faxed to you. Get a set of lights that are blue put them in your car and keep the paper work and other l...

You can use any bolt! Had the same prob last year.

The diff is the thikness of the oil 5w30 is better in the cold and 10w30 is better in the summer. There will be no change in proformance.

What the smell is unburnt gases from your tail pipe. What the cats job is to do is burn all the extra gases in the exaust. That is what the smell is so change the cat! If it was the clutch it would smell the same as brakes that are on when driving down the road.

it should be fine i have a 92 and it has over 300.000 and it still runs good.

there is one other thing to look for. In the front of the block is a pipe that runs to the water pump see if that is leaking. Our get a pressure test done on the cooling system.

there is one other thing to look for. In the front of the block is a pipe that runs to the water pump see if that is leaking. Our get a pressure test done on the cooling system.

Well where is the coolant leaking from. Is it the water pump? Or one of the hoses. What about the rad. Find out where the leak is first and get back. Cuz you don't want to over heat the motor cuz than it will cost you big time. Trust me it happend last month

No way that you will fit Rx-7 brakes on your Mx-3. the best way to do that is to put a RX-7 rearend under you car. But that will be hard to do since the RX-7 is RW drive. But if you have the time and the money good luck. And for the fuel pump well let me get back to you. Want more fuel replace the i...

Drain the oil and coolant and than drive the piss out of it! Just like that

sounds like the valve cover is the part that is leaking the best thing for that is to replace the gasket.This will take you a hole 30 min or so to do. All you need is a 8mm socket to remove the cover. Than remove the gasket and clean the valve cover up good.place in the new gasket. Then slap it back...