MX-3.com

when I trun left (especially hard left), there is a clunking/clicking sound from the right front wheel. Is this a tie rod or other issue? And can it be repaired by a novice or will it require an expensive repair job by a mechanic? Car seems to drive ok otherwise. The sound is very audible when movin...

both sensors were replaced according to the mechanic

1993 mx3 1.6

My Service Engine Light has recently started coming on. It comes on after driving for about 10-30min . It comes on and stays on for about 2-10min at a time then goes out afterwhich i lose power or cannot accelrate(stalls) for a few seconds then the car goes back to driving ok. This happens in this c...

all interioir lights work except the ignition illuminaton. I have accessed light, wiggled cable, no light ..possible Short or dead bulb. although light use to inttermittantly work.

Do I have to go to the dealer for this bulb or can I get it at any Parts store? Is it possible for there to be a short in the wire, without a short showing up somewhee else.

per last post, I got to the cable/light. I tried wiggling , and still cannot get light to work.. can the bulb be changed ? It looks like the light is a permanent bulb. how does one go about fixing . In the drak it is hard to locate ignition swithch with out the light. It use to work , then became in...

has anyone here purchased a repair manual for the 1993 1.6L Auto..online. Preferrably one by Chilton.
thanks & Happy "Sailing"

Forgive this very wierd question, But dont you have to remove the engine in order to repair engine mounts?

thanks for infro.
can a broken engine mount be fixed?

I recently had a mechanic tell me that "flushing" (changing/replacing) the tranny fluid and filter and having my tranny serviced COULD make my issues worse And I would be "taking a chance" on servicing the tranny. 1993 mx-3, 1.6L, auto tranny @ 140,000 mi (I think), engine was re...

Can anyone suggest a cause and repair for an intermittant Ignition illumination light issue?
Sometimes it works and sometimes it doesnt. A possible short perhaps?

good info thanks. I will have timing belt checked. and ask mechanic is a tune up is needed.

Thanks you all for info
will remove door panel and push lock out. I just have to get a good repair manual.. unless someone here knows how to remove door panel?

Hope I am in the right forum.
Is it possible to remove an imbedded (broken- off) key in door lock,
without having to call a locksmith or mechanic?
A pair of tweezers perhaps? I am asking before I attempt this,
in case some has had prior experience with this. I'd hate to scratch up the paint.