MX-3.com

where is the write up to install them? Im looking to pick up a set this week!

Well without any help from here it was the a/c pressure valve ran me $15 and all is good again

My a/c stopped working a few days ago... I found where the leak is. A screw on pressure valve ( i think is what is it) it screws right into the compressor on the right hand side facing downwards. Nothing is connected to it just looks like a pressure screw or something like that.... Car is a 92 1.6L ...

Sometimes my 92 doesnt hold a steady idle and bounces between almost a stall and 1k rpm. It has never stalled from this. Engine doesnt show any code's. When i put on the A/C and the compresser is engaged it idle's beautifuly ( dont know why ) Someone suggested take off the IAC and clean it? Also its...

Well changed the dizzy out today, Easy swap out and all good, Didnt retime it just kinda marked where old one was all good!

One other silly questiong, Looking on rockauto to buy a new one. They have listed ones with different diameter rotor cams? Does it matter which one i get? I would like to get the cheapest one they sell which rockauto for that one does not list differant sizes? BTW well engine turns over perfectly bu...

What exactly is the NE signal mean? In the meantime should i buy a new dizzy? I am semi-new to mazda's owned this car about a year and distributor on there looks pretty original

Hey guys, was driving my 92 all pefectly, Stalled on me in the road i pushed it off to the side. Cranks cranks cranks with no sign of turning over, checked the code it showed #2, Which i think is the distributor? Would it just die on me like that and not restart? Before this car has been very very r...

When your at idle and the car is beginning to overheat.. is your heater blowing hot at full heat setting? Or is it just luke warm? If your only getting luke warm heat from it while the temp is rising.. then its a sign that the water pump impeller is corroding away and is not moving the coolant as i...

sorry for late update but it actually turned out to be the bad water thermosensor i changed out

Any suggestions how to get this plug out without removing the fuel rail? I dont know how to get the clip off without breaking it

it was the coolant temp sender. thanks guys

Looking online for the part is it maybe called the tempature switch or the coolant tempature sender (not sensor)

Ok belive it or not i have the same problem. 92 1.6L i looked and looked and looked there is NO sensor behind the dist.. No dangling harness or anything im clueless on where it can be... Update. check out this thread http://www.mx-3.com/phpBB3/viewtopic.php?f=3&t=66120" onclick="window...

not my picture but need to know what this sensor is on the engine? mine preety much fell apart