[FS] Stainless BPT manifold (T25)

mazdax3speed · Post by **mazdax3speed** » October 8th, 2007, 12:23 am

i have a stainless tubular manifold from a DSM (bought new) with a BP bolt hole flange and a T25 flange welded over the 16g. i dont have any pictures of the inside of the manifold yet, but will wensday night. its been ported so the runners match up evenly with the flanges. i only used to drive down to concord from raleigh and back...then the crappy T25 had more shaft play then your friends hot mom after a girls drink 1/2 off night . so i would say around 300miles on it. i can have the welds grinded down and redone, they were stitch welded with a 30yr old mig. but hold just fine. i would like to get around $250 for it.

mazdax3speed · Post by **mazdax3speed** » October 10th, 2007, 3:24 pm

bump, price is neg.

mazdax3speed · Post by **mazdax3speed** » October 11th, 2007, 6:08 pm

$200 + shipping!!!!!!

mazdax3speed · Post by **mazdax3speed** » October 18th, 2007, 2:38 pm

[b]manifold and T25 sold[/b]