i have a stainless tubular manifold from a DSM (bought new) with a BP bolt hole flange and a T25 flange welded over the 16g. i dont have any pictures of the inside of the manifold yet, but will wensday night. its been ported so the runners match up evenly with the flanges. i only used to drive down to concord from raleigh and back...then the crappy T25 had more shaft play then your friends hot mom after a girls drink 1/2 off night . so i would say around 300miles on it. i can have the welds grinded down and redone, they were stitch welded with a 30yr old mig. but hold just fine. i would like to get around $250 for it.
[FS] Stainless BPT manifold (T25)
- mazdax3speed
- Regular Member
- Posts: 164
- Joined: February 12th, 2007, 6:34 pm
[FS] Stainless BPT manifold (T25)
Orange 95' BPT GT28r, MSII on the way
- mazdax3speed
- Regular Member
- Posts: 164
- Joined: February 12th, 2007, 6:34 pm
- mazdax3speed
- Regular Member
- Posts: 164
- Joined: February 12th, 2007, 6:34 pm
- mazdax3speed
- Regular Member
- Posts: 164
- Joined: February 12th, 2007, 6:34 pm