fuel injectors
-
- Regular Member
- Posts: 108
- Joined: December 14th, 2003, 2:01 am
- Location: florida
fuel injectors
i hav been hearin on this site that people are putting eclipse injectors on the b6ze turbo projects well i had a crazy idea if the injectors are them same then would a fuel rail from the eclipse work? or hell how bout aftermarket injectors and a biger fuel rail will it work?? i dont know just throwing out the idea has anyone tried if not im going to try
3-1-0 RACING club PREZ.
94' mx-3.....was all motor now awd bpt
91' 323....daily driver
78' cutless coupe...bad a-- mofo v8
95' eclipse gsx......awd turbo 11.4 eta
94' mx-3.....was all motor now awd bpt
91' 323....daily driver
78' cutless coupe...bad a-- mofo v8
95' eclipse gsx......awd turbo 11.4 eta
- papa roached
- Senior Member
- Posts: 2761
- Joined: December 10th, 2002, 2:01 am
- Location: Montgomery, WVa
Re: fuel injectors
the fuel injecots fit where ours go but the fuel rail probably wouldnt work because the spacing between injectors would be different i would think
93 MX-3 GS (collecting parts for Eunos Presso conversion), 94 626 Transmission (4.10 gears), KL31 camed KL-ZE, Millenia intake, Millenia TB, SSAutochrome V2 headers, Magnaflow cat, 2 1/4 in pipe, Top Speed Pro 1 muffler, 9lb Fidanza Flywheel, ACT clutch, Corksport SS clutch line, Corksport SS brake lines, Unorthadox UDP, 255 lph fuel pump, HEI mod, ghetto-charger intake, KL36 ECU, SRD transverse crossmember bushings, SRD shifter extention bushing, SRD crossmember, Corksport bronzoil shifter bushings, Brembo Crossdrilled and Slotted rotors, 15 inch Konig Heliums, ZX-2 S/R struts, Eibach lowering springs, OEM front strut bar, Ebay rear strut bar, BFGoodrich G-Force T/A KDWs
Parts needing installed: turbo kit from BB (if i ever get it), 9.0:1 CR Diamond pistons, 4340 forged H beam rods, C/J-Spec spoiler, Nissan red tops in KL rails
http://www.cardomain.com/id/blazejeremy
Parts needing installed: turbo kit from BB (if i ever get it), 9.0:1 CR Diamond pistons, 4340 forged H beam rods, C/J-Spec spoiler, Nissan red tops in KL rails
http://www.cardomain.com/id/blazejeremy
- jaydog5678
- Regular Member
- Posts: 1043
- Joined: March 27th, 2002, 2:01 am
- Location: Marietta, GA,
- Contact:
Re: fuel injectors
Nobody makes a bolt in fuel rail for our car. You dont even need a rail unless your attempting to make over 600hp give or take a few ponies.
The Eclipse injectors will fit, however they don't fit the stock wiring connector that plugs into them.
<small>[ August 06, 2004, 08:10 PM: Message edited by: jaydog5678 ]</small>
The Eclipse injectors will fit, however they don't fit the stock wiring connector that plugs into them.
<small>[ August 06, 2004, 08:10 PM: Message edited by: jaydog5678 ]</small>