b6t question

4-Cyl. Technical/Performance Discussions
Post Reply
FREDDY GONZALEZ_23
Regular Member
Posts: 84
Joined: June 4th, 2003, 2:01 am
Location: south padre ,Tx

b6t question

Post by FREDDY GONZALEZ_23 »

do i have to run an intercoller with mt b6t swap, i can get the intercoooler but can't run the piping cuz my bodykit is molded on. is it possible to cool the turbo any other way. :welder:
Image
Top
User avatar
papa roached
Senior Member
Posts: 2761
Joined: December 10th, 2002, 2:01 am
Location: Montgomery, WVa

Re: b6t question

Post by papa roached »

i hear liqud to air intercoolers work decent
93 MX-3 GS (collecting parts for Eunos Presso conversion), 94 626 Transmission (4.10 gears), KL31 camed KL-ZE, Millenia intake, Millenia TB, SSAutochrome V2 headers, Magnaflow cat, 2 1/4 in pipe, Top Speed Pro 1 muffler, 9lb Fidanza Flywheel, ACT clutch, Corksport SS clutch line, Corksport SS brake lines, Unorthadox UDP, 255 lph fuel pump, HEI mod, ghetto-charger intake, KL36 ECU, SRD transverse crossmember bushings, SRD shifter extention bushing, SRD crossmember, Corksport bronzoil shifter bushings, Brembo Crossdrilled and Slotted rotors, 15 inch Konig Heliums, ZX-2 S/R struts, Eibach lowering springs, OEM front strut bar, Ebay rear strut bar, BFGoodrich G-Force T/A KDWs

Parts needing installed: turbo kit from BB (if i ever get it), 9.0:1 CR Diamond pistons, 4340 forged H beam rods, C/J-Spec spoiler, Nissan red tops in KL rails
http://www.cardomain.com/id/blazejeremy
Top
Post Reply

Return to “4-Cyl. Technical/Performance”