NEED THIS DONE TONIGHT
-
- Regular Member
- Posts: 31
- Joined: December 31st, 2002, 2:01 am
- Location: Lancaster
NEED THIS DONE TONIGHT
my wheel bearings are shot and i got everything off and i can see the wheel bearing how do i get the bearing housing out?? please help i gotta get this done tonight.
i shall drop and rx-7 twin turbo in my 93 4 banger
- ryanlindenberg
- Regular Member
- Posts: 874
- Joined: February 24th, 2003, 2:01 am
- Location: Minnesota
Re: NEED THIS DONE TONIGHT
punch and hammer. be sure not to scratch the inside of the hub
CARDOMAIN WITH UPDATED PICS
"There are 2 kinds of pedestrians, the quick and the dead."
"There are 2 kinds of pedestrians, the quick and the dead."
- jaydog5678
- Regular Member
- Posts: 1043
- Joined: March 27th, 2002, 2:01 am
- Location: Marietta, GA,
- Contact:
Re: NEED THIS DONE TONIGHT
press.
Re: NEED THIS DONE TONIGHT
Good luck doing it at home. The bearing his in the center of the spindle and there's the cage that will be on the hub. to remove the bearing from the spindle you need a press and to remove the cage from the bearing you need a set of torch. you heat the cage until it's red then you put it into water and it should fall off.