[FS] Parting out modded 1994 RS ????
-
- Senior Member
- Posts: 2165
- Joined: December 7th, 2002, 2:01 am
- Location: windsor, ontario
- Contact:
[FS] Parting out modded 1994 RS ????
I have a 1994 white RS that i'm parting out.. I only have about 2-3 weeks to do this maybe a little longer but not much.
It is white pics can be seen at my cardomain page: http://www.cardomain.com/id/projectmx
Here is the aftermarket stuff i'm selling:
Shaved doors (i might keep these but if the price is right i'll sell)
Door popper kit (if i sell the doors this will come with since it's already installed)
Black Integra intake
Header back exhaust (has a few dings but worked great when i was driving the car around)
GS spoiler
SRD Control arm bushings
Front control arms (sandblasted and repainted last summer)
Pretty much everything is for sale off of it I do want to keep some parts but i might even sells those of the offer is right. I really really need to get this car gone and get the last bit of money to get my AWD mx-3 done so please please please help me I'm posting this here on clubprotege and feoa.net if anyone comes down and pulls parts off themselves I will charge less.. I can also bring some parts up to the chicago area with me if anyone needs anything and doesn't want to drive down to the kankakee area
The bad parts on the car as as follows:
Rear end was hit so rear bumper is gone and bumper support
the small shifter linkage part that is in the trans is bent and needs to be replaced to shift right
as far as i know everything else works great on the car.
let me know if you need anything and i'll try and get it for you.
engine runs great also and had a new water pump and timing belt put in last year also has a new clutch as of last year
It is white pics can be seen at my cardomain page: http://www.cardomain.com/id/projectmx
Here is the aftermarket stuff i'm selling:
Shaved doors (i might keep these but if the price is right i'll sell)
Door popper kit (if i sell the doors this will come with since it's already installed)
Black Integra intake
Header back exhaust (has a few dings but worked great when i was driving the car around)
GS spoiler
SRD Control arm bushings
Front control arms (sandblasted and repainted last summer)
Pretty much everything is for sale off of it I do want to keep some parts but i might even sells those of the offer is right. I really really need to get this car gone and get the last bit of money to get my AWD mx-3 done so please please please help me I'm posting this here on clubprotege and feoa.net if anyone comes down and pulls parts off themselves I will charge less.. I can also bring some parts up to the chicago area with me if anyone needs anything and doesn't want to drive down to the kankakee area
The bad parts on the car as as follows:
Rear end was hit so rear bumper is gone and bumper support
the small shifter linkage part that is in the trans is bent and needs to be replaced to shift right
as far as i know everything else works great on the car.
let me know if you need anything and i'll try and get it for you.
engine runs great also and had a new water pump and timing belt put in last year also has a new clutch as of last year
Last edited by projectmx on June 27th, 2007, 8:11 am, edited 1 time in total.
ProjectMx
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
-
- Senior Member
- Posts: 2165
- Joined: December 7th, 2002, 2:01 am
- Location: windsor, ontario
- Contact:
uhm i think i paid over $120 for those brand new and they only have 6 months use on them. I have them listed as $90 plus shipping on clubprotege .... i'd be willing to do $70 plus shipping but no less
ProjectMx
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
- Tunes67
- Supporting Member
- Posts: 4708
- Joined: January 27th, 2005, 6:36 pm
- Location: Everett, WA
- Contact:
Do you have or are you willing to sell any interior panels? I need the panels (both upper & lower) behind the doors. On either side of the rear seat. If they are in ok shape and you want to sell them.. how much would you charge? They should lay fairly flat so shipping shouldnt be too bad.
Tunes67
Tunes67
"So long.. and thanks for all the fish!" "Momma says VW Bugs are the devil" "This one time at band camp.. I stuck a flute in my Throttle Body"
"Screw you guys.. I am goin home"
I am the Cranky God of Mods!!! Tremble before my fury!! LOL
"Screw you guys.. I am goin home"
I am the Cranky God of Mods!!! Tremble before my fury!! LOL
-
- Senior Member
- Posts: 2165
- Joined: December 7th, 2002, 2:01 am
- Location: windsor, ontario
- Contact:
do you mean the sort of arm rest things for the rear seat passengers?
ProjectMx
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
- Tunes67
- Supporting Member
- Posts: 4708
- Joined: January 27th, 2005, 6:36 pm
- Location: Everett, WA
- Contact:
The whole panel and the smaller panel that the seat belt clip bolts through thats above the larger lower panel. And I need them from both sides of the car. Need to have the rear seats out to remove them too :S I can take pics of them if you need for positive identification
Tunes67
Tunes67
"So long.. and thanks for all the fish!" "Momma says VW Bugs are the devil" "This one time at band camp.. I stuck a flute in my Throttle Body"
"Screw you guys.. I am goin home"
I am the Cranky God of Mods!!! Tremble before my fury!! LOL
"Screw you guys.. I am goin home"
I am the Cranky God of Mods!!! Tremble before my fury!! LOL
- PATDIESEL
- Senior Member
- Posts: 4476
- Joined: August 13th, 2001, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Atlanta, GA.
Tunes, those panels look flat, but once you get them out you'll see that they have fairly long guide pins molded into the back to line them up when installing them. Might be a larger package than you think.
I am looking for the door seals. Need to be in exceptional shape for the age. specifically-
1. belt trim (outside and inside part that touches the window, must have good felt on them still and must not be bent when removing)(the interior belt trim is attached to the door panel, but I only want the seal),
2. door seal (the part that keeps water and air out when you close the door, the clips would be nice too, but are prone to break when you remove the seal),
3. little rubber trim on the upper door edge (closes the gap between the door and body panels for a clean look, I don't think they acutally serve a purpose).
4. I also need the plasic caps that go over the bolts on the wiper cowl cover. Please PM with prices incase I miss reading a reply on here.
Thanks,
Patrick
I am looking for the door seals. Need to be in exceptional shape for the age. specifically-
1. belt trim (outside and inside part that touches the window, must have good felt on them still and must not be bent when removing)(the interior belt trim is attached to the door panel, but I only want the seal),
2. door seal (the part that keeps water and air out when you close the door, the clips would be nice too, but are prone to break when you remove the seal),
3. little rubber trim on the upper door edge (closes the gap between the door and body panels for a clean look, I don't think they acutally serve a purpose).
4. I also need the plasic caps that go over the bolts on the wiper cowl cover. Please PM with prices incase I miss reading a reply on here.
Thanks,
Patrick
ZE -strait neck,headers,2.5 exhaust,pheno spacers,lower cross member,GC coils,MS struts,Brembo slotted rotors,filled MS mounts,SS brake/clutch lines, CAI,to rear bat reloc,Hella headlamps,Hella DE fogs 180WHP
- Tunes67
- Supporting Member
- Posts: 4708
- Joined: January 27th, 2005, 6:36 pm
- Location: Everett, WA
- Contact:
Yeah but even if the package is a bit large.. it wont weigh much.. so the shipping on it should still be reasonable.
Tunes67
Tunes67
"So long.. and thanks for all the fish!" "Momma says VW Bugs are the devil" "This one time at band camp.. I stuck a flute in my Throttle Body"
"Screw you guys.. I am goin home"
I am the Cranky God of Mods!!! Tremble before my fury!! LOL
"Screw you guys.. I am goin home"
I am the Cranky God of Mods!!! Tremble before my fury!! LOL
-
- Senior Member
- Posts: 2165
- Joined: December 7th, 2002, 2:01 am
- Location: windsor, ontario
- Contact:
lol pat that was so wrong
panels should be in good condition but i'll check them out friday when i pick up my car
team pk... engine is yours if you want. i'd like $250 plus shipping or depending on where you live I could work out bring it or meeting half way
pat i'm not sure about all those seals.... i think they aren't in good condition especially the door ones cause i had to break into the car once. are they not available through mazda or just too much? i'll look them over fri/sat
panels should be in good condition but i'll check them out friday when i pick up my car
team pk... engine is yours if you want. i'd like $250 plus shipping or depending on where you live I could work out bring it or meeting half way
pat i'm not sure about all those seals.... i think they aren't in good condition especially the door ones cause i had to break into the car once. are they not available through mazda or just too much? i'll look them over fri/sat
ProjectMx
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
-
- Senior Member
- Posts: 2165
- Joined: December 7th, 2002, 2:01 am
- Location: windsor, ontario
- Contact:
tunes is 30 plus shipping ok for the panels if they are in good shape? pm me and we'll try and work out the details
ProjectMx
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
-
- Senior Member
- Posts: 2165
- Joined: December 7th, 2002, 2:01 am
- Location: windsor, ontario
- Contact:
if anyone lives near me don't forget if you want to come strip parts off i'll charge less and if you come help with the the AWD mx-3 there's a good chance i'll throw free parts in for ya
i realllllly want to get my car up and running
i realllllly want to get my car up and running
ProjectMx
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving
My BP and AWD build thread
Cardomain
93 Mx-3 GS with bp and GTR AWD system
93 Escort GT daily driving