I think My clutch is going
-
- Senior Member
- Posts: 6451
- Joined: June 19th, 2004, 2:01 am
- Location: El Paso Tx U.S
- Contact:
I think My clutch is going
WHAT? after only a year a nd a few monts?? its seems it slips in high rpms.. I hope its just my tires spinning any way if finding out if itrs really slipping? should I just run it until the slippage is really bad? I know i need to buy some new friction plates for the fidanza.. but wow.. i tought they lasted years..? I do go to the drags ALOT... I hope its the tires spinning i can only feel it in 1st gear and second in high rpms.the rest it doesnt seem to slip.
-hec
MX-3 w/ curved neck millenia klde, boosted @ 5 psi. /bov and wastegate are good!/ nitto drag radial/ gutted interior/ millenia red top injectors, vortech fmu/aem wideband/ all bolts ons/ Car put together 100% by me. Mechanic? who needs a mechanic? ew.. real men work on their own cars!
MX-3 w/ curved neck millenia klde, boosted @ 5 psi. /bov and wastegate are good!/ nitto drag radial/ gutted interior/ millenia red top injectors, vortech fmu/aem wideband/ all bolts ons/ Car put together 100% by me. Mechanic? who needs a mechanic? ew.. real men work on their own cars!
- mx3autozam
- Senior Member
- Posts: 2950
- Joined: September 24th, 2005, 9:09 pm
- Location: Kitchener
what kind of clutch is it..if its stock ya a year is about right.
a good way to tell if its slipping and not tire spining. is when it revs and teh tacometer moves does the speedometer move too, if it does then its tire spin.
also at a stop with the parking brake on and in 5th gear, rev the car up a bit and try to pull away, the car should stall right away, or it would continue reving because the clutch is slipping. or drive it through 1st and 2nd gear and the go straight to 5th at really low rpm's and mash the gas if it just revs then ya she's fucked
a good way to tell if its slipping and not tire spining. is when it revs and teh tacometer moves does the speedometer move too, if it does then its tire spin.
also at a stop with the parking brake on and in 5th gear, rev the car up a bit and try to pull away, the car should stall right away, or it would continue reving because the clutch is slipping. or drive it through 1st and 2nd gear and the go straight to 5th at really low rpm's and mash the gas if it just revs then ya she's fucked
93 Mazda MX3 KLZE Turbo
- Mooneggs
- Forum Moderator
- Posts: 6128
- Joined: August 10th, 2005, 10:08 pm
- antispam: ~SPAM*SUX~
- Location: Hillsboro, OR
- Contact:
the way I figured out my clutch was going on was just driving normal in 5th gear and then flooring it... if the rpm's start going up and your speed does not increase then yeah your clutch is going.
I see you have a stage 3 clutch... I had a stage 2 CM type R and it only lasted 20k miles and then it started breaking up and destroyed my fidanza surface... you should order a surface now so it will have time to get there before you change the clutch and you're not waiting on parts...
I see you have a stage 3 clutch... I had a stage 2 CM type R and it only lasted 20k miles and then it started breaking up and destroyed my fidanza surface... you should order a surface now so it will have time to get there before you change the clutch and you're not waiting on parts...
My Feedback
92 mx-3 gs klze 'race car' IP 15.05 @ 92.5mph
92 mx-3 gs klze 'daily driver' IP 14.55 @ 95.7mph
http://www.cardomain.com/id/Mooneggs
92 mx-3 gs klze 'race car' IP 15.05 @ 92.5mph
92 mx-3 gs klze 'daily driver' IP 14.55 @ 95.7mph
http://www.cardomain.com/id/Mooneggs
-
- Senior Member
- Posts: 6451
- Joined: June 19th, 2004, 2:01 am
- Location: El Paso Tx U.S
- Contact:
Thanks guys! Ill do those tests. Im not using the car much anymore only on weekends. Ill order the surface anyway even if its not going. its been almost a year. Its a stage 3 and I DO give her hell. Im suprised the transmission has held up.
-hec
MX-3 w/ curved neck millenia klde, boosted @ 5 psi. /bov and wastegate are good!/ nitto drag radial/ gutted interior/ millenia red top injectors, vortech fmu/aem wideband/ all bolts ons/ Car put together 100% by me. Mechanic? who needs a mechanic? ew.. real men work on their own cars!
MX-3 w/ curved neck millenia klde, boosted @ 5 psi. /bov and wastegate are good!/ nitto drag radial/ gutted interior/ millenia red top injectors, vortech fmu/aem wideband/ all bolts ons/ Car put together 100% by me. Mechanic? who needs a mechanic? ew.. real men work on their own cars!
-
- Senior Member
- Posts: 6451
- Joined: June 19th, 2004, 2:01 am
- Location: El Paso Tx U.S
- Contact:
This is the clutch i have
http://cgi.ebay.com/ebaymotors/F1-RACIN ... enameZWDVW
was that a bad choice? Im looking into other brands that grab hardcore. This one grabs quite good but i havent checked the rest out.
And where can I buy the surface?
http://cgi.ebay.com/ebaymotors/F1-RACIN ... enameZWDVW
was that a bad choice? Im looking into other brands that grab hardcore. This one grabs quite good but i havent checked the rest out.
And where can I buy the surface?
-hec
MX-3 w/ curved neck millenia klde, boosted @ 5 psi. /bov and wastegate are good!/ nitto drag radial/ gutted interior/ millenia red top injectors, vortech fmu/aem wideband/ all bolts ons/ Car put together 100% by me. Mechanic? who needs a mechanic? ew.. real men work on their own cars!
MX-3 w/ curved neck millenia klde, boosted @ 5 psi. /bov and wastegate are good!/ nitto drag radial/ gutted interior/ millenia red top injectors, vortech fmu/aem wideband/ all bolts ons/ Car put together 100% by me. Mechanic? who needs a mechanic? ew.. real men work on their own cars!
- mx3autozam
- Senior Member
- Posts: 2950
- Joined: September 24th, 2005, 9:09 pm
- Location: Kitchener
-
- Senior Member
- Posts: 6451
- Joined: June 19th, 2004, 2:01 am
- Location: El Paso Tx U.S
- Contact:
sorry, i did get one for probe gt.
I cant take off from 5th however if i rev it high and slowly drop it will move and go from there ...is that normal?
I cant take off from 5th however if i rev it high and slowly drop it will move and go from there ...is that normal?
-hec
MX-3 w/ curved neck millenia klde, boosted @ 5 psi. /bov and wastegate are good!/ nitto drag radial/ gutted interior/ millenia red top injectors, vortech fmu/aem wideband/ all bolts ons/ Car put together 100% by me. Mechanic? who needs a mechanic? ew.. real men work on their own cars!
MX-3 w/ curved neck millenia klde, boosted @ 5 psi. /bov and wastegate are good!/ nitto drag radial/ gutted interior/ millenia red top injectors, vortech fmu/aem wideband/ all bolts ons/ Car put together 100% by me. Mechanic? who needs a mechanic? ew.. real men work on their own cars!
- mx3autozam
- Senior Member
- Posts: 2950
- Joined: September 24th, 2005, 9:09 pm
- Location: Kitchener