I have a 93 GS V6 (US/North American) MX-3. The little VIN thing in the door says it was MFG in '92.
I need a distributor, but I have no idea which rotor size I have. Autozone wants to know. I'm not on the factory original either, so the little part number sticker on the side is gone.
Any idea how to tell without taking it apart?
-Eric
93 MX-3 V6 Distributor
-
- Regular Member
- Posts: 142
- Joined: July 10th, 2005, 12:11 pm
- Location: Wichita, Ks
-
- Regular Member
- Posts: 187
- Joined: October 12th, 2005, 2:09 pm
- Location: Bellingham, WA
Makes no difference. Just buy the cheaper one. I know this cause i had to buy a disty.
And when i did they claimed it was gonna be a problem. When i asked to get a rotor, they said a price. I was like well arent there different sizes ?
Well no we only stock one size. I forget if its bigger or smaller, but etheir way the nipple that it goes onto, can be change if needed.
And when i did they claimed it was gonna be a problem. When i asked to get a rotor, they said a price. I was like well arent there different sizes ?
Well no we only stock one size. I forget if its bigger or smaller, but etheir way the nipple that it goes onto, can be change if needed.
I still cant find anywhere in the shop manual where it says there should be a 1in hole in the side of the block. (Blown K8) #6 rod thrown through block.
-
- Regular Member
- Posts: 142
- Joined: July 10th, 2005, 12:11 pm
- Location: Wichita, Ks
-
- Regular Member
- Posts: 187
- Joined: October 12th, 2005, 2:09 pm
- Location: Bellingham, WA
Yep.
Cap aint the problem
only the rotor.
When you buy it i would ask them for a rotor to and check it right there.
Might at well replace cap and rotor at the same time
Cap aint the problem
only the rotor.
When you buy it i would ask them for a rotor to and check it right there.
Might at well replace cap and rotor at the same time
I still cant find anywhere in the shop manual where it says there should be a 1in hole in the side of the block. (Blown K8) #6 rod thrown through block.
-
- Regular Member
- Posts: 142
- Joined: July 10th, 2005, 12:11 pm
- Location: Wichita, Ks
-
- Regular Member
- Posts: 187
- Joined: October 12th, 2005, 2:09 pm
- Location: Bellingham, WA
-
- Regular Member
- Posts: 142
- Joined: July 10th, 2005, 12:11 pm
- Location: Wichita, Ks