I have a 1993 mx-3 manual 4 cyclinder 1.6L, We recently cleaned out the air intake with specified cleaner and also cleaned out of the MAF, again with specified cleaner and now it starts fine and the RPM's go to about 1500 (for about a second), then drop to 1000 (again for a second or so) and then just dies. We put it in diagnostic mode by jumping GND and TEN and then adjusting the idle air screw. The engine was having some trouble before we cleaned everything but it would at least stay running.
Another problem is when i do start it (within the first 4 seconds before it dies), i push down on the gas and it stalls immediately. Also i think when i let up on the clutch that is stalled faster as well.
So im thinking either its the alternator (i thought this by reading other posts) or when we cleaned the air intake, we pushed some gunk back to the fuel injectors and thus thats why when i push down on the gas that it just dies.
Any help would be greatly appreciated. Thanks
-tim
Problem while starting....
More likely you have a leak in the rubber air hose - when you cleaned it you probably cracked it.
94 Mx-3 Precidia
1.8L 4Cyl DOHC newGen BP (used to be B6DE) ATX
http://www.mx-3.com/phpbb2/viewtopic.php?t=54032
http://www.cardomain.com/id/ariesdude
1.8L 4Cyl DOHC newGen BP (used to be B6DE) ATX
http://www.mx-3.com/phpbb2/viewtopic.php?t=54032
http://www.cardomain.com/id/ariesdude
I opened up the MAF by removing the black panel that is sealed by some silicone sealant. I dont really recommend it unless your absolutely sure its the MAF. We figured it out by disconnecting the MAF and then starting it up. It should idle fine but try connecting the MAF plug back in and if it dies then you know thats it.