swapping IM
-
- Regular Member
- Posts: 106
- Joined: October 17th, 2006, 12:12 pm
- Location: simcoe
- Contact:
swapping IM
k im a noob at this... but im wondeirn gif i wanted to change my intake manifold to an MS8 is it possible to do it without removing it out of the engine bay
1992 mx3 gs Klze with Powder coated black Curved neck Manifold. Hot shot performance CAI, ford probe Gt ECU and MAF
http://www.cardomain.com/ride/2197073
http://www.cardomain.com/ride/2197073
- mx3autozam
- Senior Member
- Posts: 2950
- Joined: September 24th, 2005, 9:09 pm
- Location: Kitchener
- Custommx3
- Site Administrator
- Posts: 8391
- Joined: November 7th, 2000, 2:01 am
- antispam: ~SPAM*SUX~
- Location: Lat 35.1N Lon -90W
- Contact:
YOU can swap ot with out having to remove the engine if thats what your asking. Just be sure you have plenty of vaccume hose, and have the vaccume hose diagarm with you. Id have the ms8 manifold already prepered with vaccume lines attahced before doing so. Also, make sur eyou clean the surface where it mounts to the head preior to doing so, and if there is going to be any time where the car will sit with the manifold off, cover up the ports on the heads to keep debris from entering the cylinder.
-
- Regular Member
- Posts: 106
- Joined: October 17th, 2006, 12:12 pm
- Location: simcoe
- Contact:
thanks guys
1992 mx3 gs Klze with Powder coated black Curved neck Manifold. Hot shot performance CAI, ford probe Gt ECU and MAF
http://www.cardomain.com/ride/2197073
http://www.cardomain.com/ride/2197073