BP Injector Harness
-
- Regular Member
- Posts: 675
- Joined: September 15th, 2004, 2:01 am
BP Injector Harness
The Injector Plug is an 8 pin and my 93 wiring harness is 6 pin what do i do?
- Limegreen mx-3
- Regular Member
- Posts: 1778
- Joined: October 29th, 2002, 2:01 am
- Location: San Antonio TX
- Contact:
get a bp harness
(12.4@118@18psi) 92 MX-3, KIA (BP-DE)Swap, Electromotive TEC II Standalone, 8,200 Rev Limit, Custom Intake/Exhaust Manifold, 1,000cc PTE Injectors, Custom Fuel Rail, Aeromotive FPR, 80MM Holley TB, MSD 8.5MM Wires, NGK V-Power #8, SC6262 Turbo, 3 in. DownPipe, Tial WG/BOV, 600HP PTE FMIC, 2.5IN Intercooler Piping, EQUUS/Autometer KIA G-Series Tran, Extreme ACT Clutch, Built BP in starting process.
-
- Regular Member
- Posts: 675
- Joined: September 15th, 2004, 2:01 am
- Typhoonk
- Regular Member
- Posts: 1138
- Joined: December 31st, 2002, 2:01 am
- Location: Bowmanville
- Contact:
the missing two wires are for the V.I.C.S. solenoid. Not needed to run, but will throw a code into the computer.
If you are using the B6 93 harness check out the faq. If not. Get a BP harness and enjoy the simplification.
If you are using the B6 93 harness check out the faq. If not. Get a BP harness and enjoy the simplification.
-------------------------------------------------------
Got to sell one of my cars to cover the bills
2002 Mazda Protege 5 - Manual, Blue colour fully loaded
PM for info
Got to sell one of my cars to cover the bills
2002 Mazda Protege 5 - Manual, Blue colour fully loaded
PM for info
-
- Regular Member
- Posts: 111
- Joined: July 31st, 2004, 2:01 am
- Location: Miami, FL