Anyone know what cars i could get a supercharger off that would be found in a junkyard, and would be applicable (with fabrication obvisouly) to my B6?
Bochek
Junkyard Superchargers
-
Bochek
- Regular Member
- Posts: 1704
- Joined: December 31st, 2005, 5:54 pm
- Location: Burlington + Grimsby, Ontario, Canada
- Contact:
Junkyard Superchargers
Adam Bochek's 93 1.6L SOHC http://www.bochek.ca/car.gif
-
Limegreen mx-3
- Regular Member
- Posts: 1778
- Joined: October 29th, 2002, 2:01 am
- Location: San Antonio TX
- Contact:
don't go the cheap way.
(12.4@118@18psi) 92 MX-3, KIA (BP-DE)Swap, Electromotive TEC II Standalone, 8,200 Rev Limit, Custom Intake/Exhaust Manifold, 1,000cc PTE Injectors, Custom Fuel Rail, Aeromotive FPR, 80MM Holley TB, MSD 8.5MM Wires, NGK V-Power #8, SC6262 Turbo, 3 in. DownPipe, Tial WG/BOV, 600HP PTE FMIC, 2.5IN Intercooler Piping, EQUUS/Autometer KIA G-Series Tran, Extreme ACT Clutch, Built BP in starting process.
-
Bochek
- Regular Member
- Posts: 1704
- Joined: December 31st, 2005, 5:54 pm
- Location: Burlington + Grimsby, Ontario, Canada
- Contact:
reason being, im not trying to be totally cheep, im just looking for a good value SC, i can do all my own custom fab no prob, just need the actual unit.
Bochek
Bochek
Adam Bochek's 93 1.6L SOHC http://www.bochek.ca/car.gif
-
mr1in6billion
- Supporting Member
- Posts: 961
- Joined: August 28th, 2005, 9:06 pm
- Location: Fog City
Jackson racing uses a M45 for their kit. Remaned M45s go for around 400. Found one on ebay for 425. Sport Car Compact used the JRSC in their project miata a while back, but eventually upgraded to an M62 (with modifications to make it fit). The MX should have enough room to fit it easily.
I was looking into SC's last night and found that sticking the SC in is quite a task. Some fancy work has to be done with the Power Steering since the pipes are located right above the belt. Once I have a good deal of money i'll probly just call jackson up and talk to them about it since they already have everything figured out.
I suggest you look at their pdf files to get some idea into what kind of fabrication needs to be done. Might be helpful.
G'luck. I hope your succesful (cause then I have a good idea of what i'm getting into
).
I was looking into SC's last night and found that sticking the SC in is quite a task. Some fancy work has to be done with the Power Steering since the pipes are located right above the belt. Once I have a good deal of money i'll probly just call jackson up and talk to them about it since they already have everything figured out.
I suggest you look at their pdf files to get some idea into what kind of fabrication needs to be done. Might be helpful.
G'luck. I hope your succesful (cause then I have a good idea of what i'm getting into
).