AIR FLOW SENSOR

4-Cyl. Technical/Performance Discussions
Post Reply
MX3 N IT
Junior Member
Posts: 9
Joined: January 5th, 2006, 10:17 pm
Location: va beach

AIR FLOW SENSOR

Post by MX3 N IT »

Ok i have been wondering about this for a long time so here goes... i gaven't seen anyone do it but is there some way we can bypass the aur flow sensor on our intake.. i know hondas don't even have sensors on their intake..and i know it is capable of bing done beacuse you have to bypass ur slutch sensor when your putting in a remote start on a manual tranny... can anyone explain?
thanks
torpedan
Regular Member
Posts: 1430
Joined: January 5th, 2002, 2:01 am
Location: DFW

Post by torpedan »

Someone asked about this recently if you use the search function to get a bit more information than i am going to say.


Is it possible? Yup, is it easy, nope. Is it Cheap, uhhhh nope. Is it worth it, that is up to you but i would say no. Unless your going to be putting down good numbers with a turbo i wouldnt worry about it.
-torp.
I don't own a Mazda.
User avatar
Yoda
Regular Member
Posts: 853
Joined: January 4th, 2003, 2:01 am
Location: Earth, solar system, Milkyway, etc

Post by Yoda »

Yes Honda's and GM engine do have a air flow sensor. The old trapdoor air metering system is generally refered to as a volume airflow sensor (VAF). The new cars use a mass air flow (MAF) sensor. The type used by Honda and GM is a manifold air pressure (MAP) sensor. The reason you don't see a MAP sensor is because it can be mounted anywhere as long as it is supplied a good manifold pressures signal. Yes there are kits to allow you to use a MAP sensor inplace of the VAF or MAP sensor. The MAP sensors are about $20 to 50. Then you need a signal converter that will translate the the signal from the MAP and converter it to a volt or milliamp signal that will match the stock datatable stored in the ECU. Simple to this point so why are people making the modification? these converters sells for between $450 to $900 then you will have to either pay for the software that translates the MAP signal to a signal the ECU will understand to make your engine to run that is if someone has already developed a datatable that you could buy. In most cases you will probably have to buy hours and hours of dyno time and program your own datatable just to get you engine to run close to stock. From here you have to spend more time and money to fine tune it. In the end you have just spent over $1000 just to get back to stock performance.
User avatar
mr1in6billion
Supporting Member
Posts: 961
Joined: August 28th, 2005, 9:06 pm
Location: Fog City

Re: AIR FLOW SENSOR

Post by mr1in6billion »

MX3 N IT wrote:and i know it is capable of bing done beacuse you have to bypass ur slutch sensor when your putting in a remote start on a manual tranny... can anyone explain?
thanks
hahahawtf?!

You can bypass the maf because you can bypass a neutral safty switch? The systems arn't related in any way. Your comparing apples to beef.
MX3 N IT
Junior Member
Posts: 9
Joined: January 5th, 2006, 10:17 pm
Location: va beach

Post by MX3 N IT »

true.. i didn't think of it that way..thanks
Post Reply

Return to “4-Cyl. Technical/Performance”