KFZE gasket and injector questions
-
Mnemonic
- Forum Moderator
- Posts: 3415
- Joined: September 3rd, 2002, 2:01 am
- Location: Eastern Hemisphere
- Contact:
you can use the same fuel pump it works fine, dont know about the gaskets for the injectors but im pritty sure they all work for the k series.
08 Infiniti G37s 6speed (The Daily)
Stillen Cold Air Intake, Z1 Plenum Power Mod, Z1 Headers, Z1 Test Pipe, OBX (Ark) Exhaust, Up-Rev Osiris Engine Management (Tuned at Z1), 20x9" 20x10" Str Racing Concave Staggered Rims, SPC Camber kit, Tein H Techs Springs
01 Lexus Is300 (LS2 Project)
93 Mx3 SE 2.5 KLZE (sold it)
93 Mx3 GS 2.0 KFZE (killed it)
Stillen Cold Air Intake, Z1 Plenum Power Mod, Z1 Headers, Z1 Test Pipe, OBX (Ark) Exhaust, Up-Rev Osiris Engine Management (Tuned at Z1), 20x9" 20x10" Str Racing Concave Staggered Rims, SPC Camber kit, Tein H Techs Springs
01 Lexus Is300 (LS2 Project)
93 Mx3 SE 2.5 KLZE (sold it)
93 Mx3 GS 2.0 KFZE (killed it)
-
lakersfan1
- Senior Member
- Posts: 3825
- Joined: June 26th, 2003, 2:01 am
- Location: Puyallup, WA
And how are KLZE and KLDE injectors different since they're both blue tops?Mnemonic wrote:he could use klde injectors but they will lean out his car, as the kfze injectors are the same as the klze injectors.hgallegos915 wrote:cant you use klde injectors? i think those would work. Leaking injectors IS DANGEROUS..if your wires begin to arc if WILL catch fire...i can tell you from experience..
As for gaskets for the injectors, they're just O-rings. You can try and have the parts store find the same size O-ring in a catalog, or you can just apply a THIN coat of RTV sealant to the O-ring and slap it in. Usually the O-rings jsut get hard over time, but a little RTV will create a small flexible barrier to allow it to seal again.
