Ok, im not COMPLETELY mechanically clueless, but im not an expert either. I bought a clutch set from exedy awhile back, and ive been meaning to install it. I remember i had asked on the forum back then too, and the general response was that its not really all that hard to do. I decided that i should try to get this done now in the summer, and ive read the chilton manual and the online shop manual and im just completely confused. What is all these special tools i need? are they really necessary? something about engine support mount, etc. There's a whole plethora of things that the online shop manual says i need and im at a loss as to where im supposed to obtain these.
Would one of my inexperience actually try to go through with this? Or should i take the safe route and take it to a shop? And if so, usually how much would a clutch installation cost?
And can anyone that knows something about installing a clutch tell me the GENERAL steps of completeing this? the manual im reading is a little too specific so im just completely lost. i dont understand a single thing theyre saying. /me is stupid.
Any help, suggestions, comments, anything would help me at this point. Im just so god deng frustrated.
![Embarassed :oops:](./images/smilies/icon_redface.gif)