Standalone engine management
Standalone engine management
what are the best standalone engine management companies?
Do I need to get a specific ecu for the BPT motor?
Where do I get an ecu in canada?
Do I need to get a specific ecu for the BPT motor?
Where do I get an ecu in canada?
Few of my Honda friends us Greddy E-Management
93 GS, KLZE, KL31 ECU, Centerforce Stg 3 Clutch, 2.25" Exhaust w/Flowmaster muffler, OBX Headers, Pheno Spacers, Front & rear X-drilled/slotted Rotors, KVR pads, SS brake & clutch lines, Ractive Filter, H&R Springs, Tokico Blue Struts, 8mm Accel Wires, MSD 6A w/ Blaster 2 Coil, HVAC Indiglo Panel. *Sold*
06 Eclipse GT *Sold*
08 Evo X GSR *Current*
06 Eclipse GT *Sold*
08 Evo X GSR *Current*
- monty73741
- Forum Moderator
- Posts: 2651
- Joined: February 11th, 2001, 2:01 am
- Location: baltimore,md usa
- Contact:
if you have a DOHC the ecu wont fit, from my understanding
Jason Danaher
Please Help Support MX-3.com
MX-3.com Online Store - http://www.mx-3.com/osv3
CafePress - http://www.cafepress.com/mx3com
Please Help Support MX-3.com
MX-3.com Online Store - http://www.mx-3.com/osv3
CafePress - http://www.cafepress.com/mx3com
-
- Senior Member
- Posts: 3391
- Joined: November 30th, 2001, 2:01 am
- Location: Stuttgart, Deutschland
- Contact:
MEGASQUIRT!
open-source in nature........practically free if you assemble yourself, all kinds of support & additional software you can rig.
the only downside.....it takes a lot of research to learn what you do and don't need.
But thats a downside to any replacement ECU system.....hooking it up will always be a b---- and deciding what features to use/not use is also another chore.
open-source in nature........practically free if you assemble yourself, all kinds of support & additional software you can rig.
the only downside.....it takes a lot of research to learn what you do and don't need.
But thats a downside to any replacement ECU system.....hooking it up will always be a b---- and deciding what features to use/not use is also another chore.
Noble Green Metallic 93' GS Hybrid, 91' 1.8 323
DONATE TO MX-3.COM
DONATE TO MX-3.COM
- babyblueMX3
- Supporting Member
- Posts: 3755
- Joined: February 23rd, 2003, 2:01 am
- Location: Gatineau,Quebec,Canada
- Contact:
I have a megasquirt..just need to get a damn laptop to install it
RIP 400whp ZE-T MX-3
Current car : Golf 01 GTI 1.8T (15 psi)
Current car : Golf 01 GTI 1.8T (15 psi)
-
- Regular Member
- Posts: 104
- Joined: January 12th, 2005, 12:14 am
corksport piggy back
I recently visited corksport and the have a piggyback system that eliminates the vortex mass flow sensor and changes it to a speed density system it allows you to program fuel and timing curves and use bigger injectors. Bit pricey though $695