I have been coming to the forum on-and-off for a few years now trying to amass as much knowledge as possible for a turbo project on my 96 RS. I can say that this forum has been absolutely indispensable.
Question - Would an IHI turbo (RHB52W) for a 1988-92 2.2L Ford Probe GT be a direct bolt-on to an exhaust manifold from a 88-89 323 GTX?
I believe that the IHI turbo (RHB52W) from an 1988-92 2.2L 626/MX-6 should - just wanted to verify if the same applied to the turbo for the same year(s) Probe GT. Many thanks.
Will this turbo fit a 323 GTX exhaust manifold?
- exdream_mx3
- Regular Member
- Posts: 327
- Joined: April 19th, 2003, 2:01 am
- Location: Hanover, PA
- Contact:
- facko
- Regular Member
- Posts: 224
- Joined: February 27th, 2005, 1:25 pm
- Location: beaufort, sc
- Contact:
i have the vj-11 too and it does work but as nos92 said the acutator hits the block. now being the fabricators me and my dad are, we managed to bend the mount for the actuator and extend the acuator rod enough to make it fit. it was all well worth the work tho the turbo makes the mx-3 alot funner to drive...and plus its always nice to watch some guys ego die after u beat their gt mustang
BP swap -- Pacesetter Header -- Custom CAI -- Custom 2.5 Exhaust w/ a Thrush Glasspack and 40 Series Flowmaster -- SPEC Stage 2 Clutch Kit
- exdream_mx3
- Regular Member
- Posts: 327
- Joined: April 19th, 2003, 2:01 am
- Location: Hanover, PA
- Contact: