problems with b6t

nos92mx3 · Post by **nos92mx3** » April 26th, 2005, 4:37 pm

Well over the winter i replaced the head gasket and the turbo on my b6t reason being they were both no good. now it will not start, the cams are dead on i also have checked for the keyway probelms and found that none exist. ( i removed the pulleys and check the key way for cracks and sloppiness with the woodruff key and that checks out. Now i have gotten the car to fire but it only runs on 2 cylinders. so my next idea was to check the compression, with the engine cold they were all in the mid-low 130's. Im stumped

Any suggestions?

ertaisi · Post by **ertaisi** » April 27th, 2005, 2:12 am

Shot in the dark here...have you messed with the distributor at all? Could running on 2 cylinders be caused by an incorrectly installed cap?

nos92mx3 · Post by **nos92mx3** » April 27th, 2005, 4:36 pm

yes i did mess with the disty but only after i discovered that it was only running on 2 cylinders. i then replaced both the cap and rotor to see if maybe that was the problem but was not