Sorry, I don't have that information, but if the resistance is infinity, it sounds good.Originally posted by Mariusz:
Correct, there is a a small box connected to the body of the distributor and on the other end trough a thin cable to the A 3pin. There is no short trough it, but also the resistance of it is inifinity. What capacity should it have ?
Dead MX-3
Re: Dead MX-3
Re-shaped and re-sized gearshift lever. Best driveability mod you can do!
Extra thick soundproofing in the boot (trunk) to quieten my stainless steel exhaust system
Extra thick soundproofing in the boot (trunk) to quieten my stainless steel exhaust system
-
- Regular Member
- Posts: 60
- Joined: December 16th, 2003, 2:01 am
- Location: Warsaw/Poland
- Contact:
Re: Dead MX-3
Tomorow i will put my MX-3 to the workshop, i don't have any idea whats wrong. And it still don't want to start.
Dreaming about K8 to KJ swap :]
-
- Regular Member
- Posts: 60
- Joined: December 16th, 2003, 2:01 am
- Location: Warsaw/Poland
- Contact:
Re: Dead MX-3
My MX-3 is back on the wheels Thanks to the new ignition module.
Dreaming about K8 to KJ swap :]
Re: Dead MX-3
Good news! Now why was it ok when it was tested in the lab - didn't they test the coil with the module?Originally posted by Mariusz:
My MX-3 is back on the wheels Thanks to the new ignition module.
Re-shaped and re-sized gearshift lever. Best driveability mod you can do!
Extra thick soundproofing in the boot (trunk) to quieten my stainless steel exhaust system
Extra thick soundproofing in the boot (trunk) to quieten my stainless steel exhaust system
-
- Regular Member
- Posts: 60
- Joined: December 16th, 2003, 2:01 am
- Location: Warsaw/Poland
- Contact:
Re: Dead MX-3
Probably not. But why they told me that the ICM is OK I don't know. That was the reason of my troubles because I had information that module is OK.
Dreaming about K8 to KJ swap :]