MX-3.com

it was in limp mode. there was a plug undone. but thanks for the help.

i did a atx to mtx swap and on the first test run everything went good. on second go at it on my way home the car lost all of its power. still runs nothing is knocking or smoking starts fine everything seems to be alright but there is no power. everheard of such a thing. and if so what could cause it.

if you did a atx to mtx swap how do you get the light to go off.

i have a 6 banger and i was wondering if the shifter rod will work off a 4 cylinder

i need the pics of the plugs that are suppose to be jumped. its in the directions but the pics are missing.

im doin an auto to manual swap. i got every thing hooked up and i get nothing. everything else electrical seems to work. just not the starter. any suggestions on what ive done wrong.

ok lets try this differntly. i am doing an auto tranny to manual tranny swap with a 1.8L. my question is can i get axles off of any other car or tranny that will work with my 1.8 manual tranny.

im doin an atx to mtx and i am having trouble locating cv joints. its a 1.8L. my question is are there any other cars that are interchangable with the mx3

no when it was removed at the junk yard they must have pulled the wires completely off.

hey guy to make that actually a cold air intake you need to build something to put over the hole where the tubing goes down into. then seal it with some gasket sealer. its easier to get off when you have to clean the filter. the way you have it now your still getting hot air from inside your engine ...

im doing an auto to manual swap. i was wondering if the back up light switch can be replaced. i guess during the removal at the junk yard the wires were ripped out. was wondering if the part sticking out of the tranny can be replaced.

no im going at it blind folded. never done anything like this before. have been asking alot of questions. wondering if you could fill me in on some of the troubles you came across.

right on... also i need to know what to do with the clutch alignment tool. im doing an auto to manual swap. if you know what one is and what to do with it.

ok sorry i didnt realize i said flywheell at the beginning, by bad. now that we are on the same part. you say there are 4 bolts on the back of the flex plate, behind the torque converter. would explain why i cant get it off

i have an auto tranny
i have an auto tranny
i have an auto tranny