would a mx-3 gs mass airflow sensor work
in fc rx-7 1990
the mx-3 sensor has a bigger diameter than the one on the rx-7
but the connector are exactly the same
would it make any difference or not
mx-3 and rx-7
- Ryan
- Senior Member
- Posts: 7198
- Joined: April 7th, 2008, 1:06 pm
- antispam: ~SPAM*SUX~
- Location: Manitoba
Re: mx-3 and rx-7
All I know is the FI RX-7's can, not sure why, but can use some of the I4 trap door style VAF's.
GS ones are the cone style, and I've never heard of an RX7 one being similar, so...
No, I don't know, and I don't think anyone does. Check the wiring diagrams, and check the diagnostics of each one to see if it has similar readings.
I doubt it, though.
GS ones are the cone style, and I've never heard of an RX7 one being similar, so...
No, I don't know, and I don't think anyone does. Check the wiring diagrams, and check the diagnostics of each one to see if it has similar readings.
I doubt it, though.
Now with Moderator power!
Black '93 BP RS - wrecked, parted, scrapped.
Green GS - Sold.
Black GS - Summer DD/Race car - Fancy KLZE
Red GS - K8-ATX -> MTX-KLDE - Frakencar. Scrapped
White GS - Rusty. Parts. Scrapped
1997 BMW M3 - my summer baby
2002 BMW 325Xi - sold
2003 Forester Xti - EJ20K swapped.
Feedback
Black '93 BP RS - wrecked, parted, scrapped.
Green GS - Sold.
Black GS - Summer DD/Race car - Fancy KLZE
Red GS - K8-ATX -> MTX-KLDE - Frakencar. Scrapped
White GS - Rusty. Parts. Scrapped
1997 BMW M3 - my summer baby
2002 BMW 325Xi - sold
2003 Forester Xti - EJ20K swapped.
Feedback
Re: mx-3 and rx-7
i put the one of my gs on my fc because the fc what shutting off
so far its been ok but i was trying to make sure that it would work on the rx-7 because is a lot easier to get the mass air flow for the mx-3
so far its been ok but i was trying to make sure that it would work on the rx-7 because is a lot easier to get the mass air flow for the mx-3