1.6 sohc distributor
-
- Junior Member
- Posts: 18
- Joined: April 1st, 2009, 11:34 pm
1.6 sohc distributor
from what car can i pull an upgrade for the 1.6 sohc?
- Limegreen mx-3
- Regular Member
- Posts: 1778
- Joined: October 29th, 2002, 2:01 am
- Location: San Antonio TX
- Contact:
Re: 1.6 sohc distributor
that part u really can't other parts of ur sohc u can upgrade.. but u won't get a big difference in power..
(12.4@118@18psi) 92 MX-3, KIA (BP-DE)Swap, Electromotive TEC II Standalone, 8,200 Rev Limit, Custom Intake/Exhaust Manifold, 1,000cc PTE Injectors, Custom Fuel Rail, Aeromotive FPR, 80MM Holley TB, MSD 8.5MM Wires, NGK V-Power #8, SC6262 Turbo, 3 in. DownPipe, Tial WG/BOV, 600HP PTE FMIC, 2.5IN Intercooler Piping, EQUUS/Autometer KIA G-Series Tran, Extreme ACT Clutch, Built BP in starting process.
-
- Junior Member
- Posts: 18
- Joined: April 1st, 2009, 11:34 pm
Re: 1.6 sohc distributor
so as far as your concerned whats the best things to do for the sohc? do you know of any after market cams?
-
- Regular Member
- Posts: 174
- Joined: November 22nd, 2008, 2:20 pm
- Location: Sydney, Nova Scotia
Re: 1.6 sohc distributor
There isnt much at all for the 1.6 sohc except plugs, wires, cone filter, coil. If you are looking for power, you are better off swapping in a BP. 40hp for around $500 for the swap is better than spending roughly $200 for a cam that will get you maybe 5-10hp.
93 323 Bp'd, Front and rear strut braces, Mx-3 seats, JDM headlights and grill SOLD
93 Mx-3 GS Curved-Neck KLZE, 5 speed Conversion, Fidanza Flywheel, Cross Drilled Rotors
93 Mx-3 GS Curved-Neck KLZE, 5 speed Conversion, Fidanza Flywheel, Cross Drilled Rotors