Ebay clutch and flywheel

General Mazda MX-3 Discussions
Post Reply
MazdaNoob123
Regular Member
Posts: 187
Joined: October 12th, 2005, 2:09 pm
Location: Bellingham, WA

Ebay clutch and flywheel

Post by MazdaNoob123 »

well since ebay can be kind of unsafe i was wondering if anyone had used anything from this place
http://stores.ebay.com/Aimco-Clutch-Co
I still cant find anywhere in the shop manual where it says there should be a 1in hole in the side of the block. (Blown K8) #6 rod thrown through block.
ninjajim4
Regular Member
Posts: 1163
Joined: December 18th, 2004, 2:01 am

Post by ninjajim4 »

i have an XTD stage 2 clutch off ebay... it's not bad. pressure plate feels a lil too soft, but a thing like that is personal preference. main thing is it grips well and it's lasted, though i hardly ever beat on it. i think i might even have bought it from that exact seller. with that many feedbacks you're sure not to get scammed, but big sellers like that can be hard to communicate with as well
hgallegos915
Senior Member
Posts: 6451
Joined: June 19th, 2004, 2:01 am
Location: El Paso Tx U.S
Contact:

Post by hgallegos915 »

hmm wow 500 dllrs :S for that kind of money you can get a FIDANZA fly and a gripforce clutch, it grabs HARD but it will only last about a year or so.(depending on your driving)


They are meant to "feel and act" like a stage 3 but last less.


It was a good bang for the buck imo before i upgrade.


The fidanza wakes up the engine a bit good :)
-hec

MX-3 w/ curved neck millenia klde, boosted @ 5 psi. /bov and wastegate are good!/ nitto drag radial/ gutted interior/ millenia red top injectors, vortech fmu/aem wideband/ all bolts ons/ Car put together 100% by me. Mechanic? who needs a mechanic? ew.. real men work on their own cars!
MazdaNoob123
Regular Member
Posts: 187
Joined: October 12th, 2005, 2:09 pm
Location: Bellingham, WA

Post by MazdaNoob123 »

I still cant find anywhere in the shop manual where it says there should be a 1in hole in the side of the block. (Blown K8) #6 rod thrown through block.
Mnemonic
Forum Moderator
Posts: 3415
Joined: September 3rd, 2002, 2:01 am
Location: Eastern Hemisphere
Contact:

Post by Mnemonic »

the clutch may be good but i dunno about the flywheel, looks similar to fidanzas flywheel just minus the ability to replace the surface ring, so in the end you would have to replace this entire flywheel, unlike with the fidanza where you pay 50 bucks to replace the surface ring.
08 Infiniti G37s 6speed (The Daily)
Stillen Cold Air Intake, Z1 Plenum Power Mod, Z1 Headers, Z1 Test Pipe, OBX (Ark) Exhaust, Up-Rev Osiris Engine Management (Tuned at Z1), 20x9" 20x10" Str Racing Concave Staggered Rims, SPC Camber kit, Tein H Techs Springs

01 Lexus Is300 (LS2 Project)
93 Mx3 SE 2.5 KLZE (sold it)
93 Mx3 GS 2.0 KFZE (killed it)
Post Reply

Return to “General Mazda MX-3”