Hi,
I am trying to pull codes (if I have any) from my UK 92 1.8 V6 MX-3,
I am putting a LED between GND & TEN, When i switch ignition to ON, The LED comes on and the VRIS valves click open and closed, so it looks like it is testing, however the LED just stays on!
Does this mean all is ok? or is there something I am missing?
Thanks
Jon
Help with Pulling Codes!
-
- Regular Member
- Posts: 33
- Joined: February 26th, 2006, 6:22 pm
- Location: United Kingdom
Help with Pulling Codes!
UK 94 2.5L KL-ZE V6 MX3, KL-68 TB, Chipped ECU, Green Air Kit, Exceedy Race Clutch, Hand made exhaust system, Goodridge Braided Brake Lines, Black Diamond Drilled & Grooved Disks with Black Diamond Predator Pads
The light has to go between FEN & B+ and TEN & GND has to be jumped.
94 Mx-3 Precidia
1.8L 4Cyl DOHC newGen BP (used to be B6DE) ATX
http://www.mx-3.com/phpbb2/viewtopic.php?t=54032
http://www.cardomain.com/id/ariesdude
1.8L 4Cyl DOHC newGen BP (used to be B6DE) ATX
http://www.mx-3.com/phpbb2/viewtopic.php?t=54032
http://www.cardomain.com/id/ariesdude
-
- Regular Member
- Posts: 33
- Joined: February 26th, 2006, 6:22 pm
- Location: United Kingdom
Yeah I tryed that too and the light stayed on!
I also did the remove Neg from batt, then press brake for 20 secs!
But only did the test I said above, I will try again tomorrow!
Thanks
Jon
I also did the remove Neg from batt, then press brake for 20 secs!
But only did the test I said above, I will try again tomorrow!
Thanks
Jon
UK 94 2.5L KL-ZE V6 MX3, KL-68 TB, Chipped ECU, Green Air Kit, Exceedy Race Clutch, Hand made exhaust system, Goodridge Braided Brake Lines, Black Diamond Drilled & Grooved Disks with Black Diamond Predator Pads
-
- Regular Member
- Posts: 33
- Joined: February 26th, 2006, 6:22 pm
- Location: United Kingdom
I cleared the codes, went for a drive, then tryed the TEN - GND while the car was off!
Jon
Jon
UK 94 2.5L KL-ZE V6 MX3, KL-68 TB, Chipped ECU, Green Air Kit, Exceedy Race Clutch, Hand made exhaust system, Goodridge Braided Brake Lines, Black Diamond Drilled & Grooved Disks with Black Diamond Predator Pads
-
- Regular Member
- Posts: 33
- Joined: February 26th, 2006, 6:22 pm
- Location: United Kingdom
K, I checked again yesterday,
Wired TEN - GND & LED on FEN - B+
The LED came on for a few seconds then went off and stayed off! I assume this means there are no codes?
Jon
Wired TEN - GND & LED on FEN - B+
The LED came on for a few seconds then went off and stayed off! I assume this means there are no codes?
Jon
UK 94 2.5L KL-ZE V6 MX3, KL-68 TB, Chipped ECU, Green Air Kit, Exceedy Race Clutch, Hand made exhaust system, Goodridge Braided Brake Lines, Black Diamond Drilled & Grooved Disks with Black Diamond Predator Pads