[GI] Partout of Ryan's MX

[Ryan]

Its time for her to retire due to the front end being bent 2" to the left.

This is still a gauging interest thread as I only plan to strip it down in 6 weeks or so.

Parts of interest:

Horizontal LED black projectors
SS MX-3 door sills
plastic interior chrome door handles and e-brake button
shift boot intact
drivers side window switch
mini sides
stock window visors (not the narrow ones)
sunroof shade is in ok condition
front brakes are 1 season old, Hawk HPS
rear calipers are good, but red and dirty.
a few good distributors
clear side markers (right signal is broken)


willing to sell powertrain, but you'd have to figure out shipping.
fully rebuilt KLDE with KLZE pistons, Colt full race grind cams, interprep springs, port matched milli manifold, full 2.5" exhaust with short tube headers, Magnaflow muffler. , maybe 20k old. This engine has put a lot of more expensive cars to shame.


I'll add more stuff as I remember what I have laying around...

[diezzel]

Would like the SS Sills, vent visors , roof visor and your mini sides . Let me know. .

[diezzel]

Pmd you as well . Thanks

[SuperK]

I would like the window visors

also a (or a couple if they're cheap) distributor

[Dali]

How much would you be willing to sell off the motor and exhaust? The headlights as well. Thanks.

[RogueWolf]

PM'd for the lights, sills and brakes.

[WhiteFinish]

no !!

[Thefez]

interested in the clear signals and the crome interior pieces also pieces of the motor if your willing to break it down.

[Ryan]

There was a lot of interest in stuff.

Unfortunately my other beater MX is having electrical ghosts that make it unreliable enough that I can't risk driving it anymore. That car was great though. Rusty, bad rattlecan job, doors hardly close, but KLDE swapped, haha.

so I will likely switch out the suspension on this car (cause 2" ground clearance doesn't work in central Canadian winters) and drive it this winter, parting it out in the spring.

[mazdaspeed23]

How much for the headlights

[Juans_93_MX3]

I'm interested in the headlights aswell

[Ryan]

Hi all,

Its been a year since I posted this? Wow. Whoops.

I've posted a Kijiji add in case I could sell some stuff local. Winnipeg isnt a big MX-3 enthusiast city, though.

http://www.kijiji.ca/v-view-details.htm ... 1085185395

Thats the stuff I have ready to go. I'll be PM'ing you all in order of reply, to see if you're still interested.

[WhiteFinish]

I'd take that window switch + stainless door sills of your hands.

[rece]

sent you an email from the kijiji post about some parts