Hi
I AM DESPERATE FOR THE MEASUREMENT OF A DECAT PIPE FROM A KLZE/KLDE THAT HAS MX-6 HEADERS AND DOWNPIPE GOING TO AN MX-3 STANDARD FITTING EXHAUST
The reason is over here in the UK I have a company that is willing to convert its current MX-6 stainless steel race headers and down pipe design so they can be built exactly to fit any standard V6 mx-3 to a standard CAT or decat pipe.
This will be the only company that will mass produce these and are willing to ship worldwide at around the $200 plus postage
The sooner I can get this rolling the sooner another race manufacturer will start producing off the shelf stuff for MX-3's as if these go well they will look at other products to develope
klze decat pipe measurement
-
- Regular Member
- Posts: 36
- Joined: September 25th, 2009, 4:13 pm
- antispam: No
-
- Regular Member
- Posts: 1751
- Joined: November 2nd, 2009, 3:03 am
- antispam: No
- Location: Vancouver, BC
Re: klze decat pipe measurement
i have hot shot headers and i had to cut off around 8" of pipe...