MX-3.com

Hey looking for a front K8/KL exhaust manifold, with either good studs or usuable threads if the studs are pulled...i need the "short" manifold, only a few inches tell.

Also need a clutch slave cylinder, I believe all K8/KL are the same, all the way into the KLG4 engine.

located north of Barrie, so i can meet around there, or if you can ship that'll work too, thanks.

Jack

PM'd

Mazda_Powered wrote:Hey looking for a front K8/KL exhaust manifold, with either good studs or usuable threads if the studs are pulled...i need the "short" manifold, only a few inches tell.

Also need a clutch slave cylinder, I believe all K8/KL are the same, all the way into the KLG4 engine.

located north of Barrie, so i can meet around there, or if you can ship that'll work too, thanks.
Jack

You should buy a new clutch slave cylinder. Its not worth installing an old one. Just a Pain to do it again. Just my advice. See if it is cheaper to get headers made before u buy a square block of steal mx-3 exhaust manifold lol.

I forgot you still needed that manifold Jack. I still have mine from the mx3. You know how to reachme best