MX-3.com

I was just wondering if anyone has a Curve neck intake manifold with the TB, fuel rails and everything else I needed for plug and play that I can put on to my KL31-101 or knew where I could get one.

PM me if you got one

Shipping to British Columbia, Canada. Thanks.

I have one in the basement that will not be used. I still need it to show me how to put the vac lines back, but in around a week or so, I would let it go for $200+shipping. comming from okotoks ab so shouldnt be too bad.

PM me if you are interested.

Regards.

have one too, 200 + shipping, its painted and cleaned recently, comes with tb, fuel rails, and everything for plug and play. could be shipped s early as monday, if u pay earlier ill let it go for a bit cheaper.

$200 holy moly, i just sold mine for $50

thanks lol, i bought mine for 200 + shipping and it was dirty as hell i had to clean it which cost me alot of money and i had to sand it and paint it. you can sell yours for $20 for all i care but the millenia manifold is being sold on this forum for around $200, and i've said repeatedly in my posts that the prices are very negotiable...

hharb wrote:thanks lol, i bought mine for 200 + shipping and it was dirty as hell i had to clean it which cost me alot of money and i had to sand it and paint it. you can sell yours for $20 for all i care but the millenia manifold is being sold on this forum for around $200, and i've said repeatedly in my posts that the prices are very negotiable...

That's BS. You totally high balling him. There's been quite a few members on this board selling curved neck IM's for $100 and less. I just bought two for $50. If he wasn't in Canada, I'd ship him one for $100 flat. Those IM's aren't worth $200 anymore, you can get them at the junkyards easier now.

seen em on ebay for around 120 - 150ish