V6 Badge Removal

bloodred · Post by **bloodred** » November 17th, 2007, 12:50 am

Apologies, if this is a dumb question, but how does one remove the rear hatch V6 badge? is it just double-sided-foam-taped on? or is there clips in behind there somewhere?

cheers

OutlaW · Post by **OutlaW** » November 17th, 2007, 4:16 am

no clips, just glue ...

umcamara · Post by **umcamara** » November 17th, 2007, 5:33 am

You'll also wanna have a can of WD-40 or some kind of residue remover. Some of the badges can leave a real hard residue that takes some work to get off.

rekognize · Post by **rekognize** » November 17th, 2007, 6:27 pm

Use a plastic ruler together with WD-40 and scrape away

Kirk95gs · Post by **Kirk95gs** » November 17th, 2007, 9:10 pm

yeah its double sided tape..... wd-40 will work, any type of solvent.. but remember when installing use a good quality tape.. 3m or something.. and make sure you clean the surface .. use rubbing alcohol and then tape.

umcamara · Post by **umcamara** » November 17th, 2007, 9:44 pm

Kirk95gs wrote:yeah its double sided tape..... wd-40 will work, any type of solvent.. but remember when installing use a good quality tape.. 3m or something.. and make sure you clean the surface .. use rubbing alcohol and then tape.

Or better yet, IMHO, leave them off for a nice CLEAN look.

bloodred · Post by **bloodred** » November 17th, 2007, 10:20 pm

that was the plan.

thanks everyone.