MX-3.com

Posted: **September 25th, 2007, 9:52 pm**

Okay so quick question.

On the one I bought the adapter which is like a back plate sort off gas a nipple on one side which goes to a hose that goes to the actual afpr. But on the other side of the plate its flat as a wall and the stock has a nipple that goes into the fuel rail. Andy said to just buy an o ring and that would do it. Just needed to know how you guys did it or what you used. Thanks.

Posted: **September 26th, 2007, 9:25 am**

Mine came with 2 different adapters. One like you described, flat on one side and a nipple on the other side. The second one was very similar to the first accept the flat side had a groove for the o ring.
The flat one without the groove will not seal at all.

sorry your kit did not come with the second one.
you will have to improvise.

Andy

Posted: **September 26th, 2007, 12:20 pm**

you could always go for the direct fit one by mbx http://www.mbxmotorsports.net/store.htm

Posted: **September 26th, 2007, 12:33 pm**

that would work but you'd still need a threaded nipple.
not to mention the cost of that adapter is more than my whole AFPR kit.

Andy

Posted: **September 26th, 2007, 2:55 pm**

Mine came with the one that has a grove

Posted: **September 26th, 2007, 3:27 pm**

I used the stock o ring from our stock fuel pressure regulator. works pretty well.

Posted: **September 27th, 2007, 11:38 pm**

Heres the pic you requested.

It came with my afpr so i dont know where he got it.. I know mnewmonic or someone has it posted somewhere.