Camber Kit
Posted: September 21st, 2007, 8:25 pm
where can i find a cheap adjustable camber kit for my mx-3? cause right now i am tearin the s--- out of my slicks and thats not to good.
Page 1 of 1
Posted: September 21st, 2007, 8:51 pm
ebay sells camber bolts..if that helps ? lol
Posted: September 21st, 2007, 8:59 pm
How low are you? What kind of suspension you got?
Posted: September 21st, 2007, 9:30 pm
i've got stock struts and 4 yr. old intrax spring's that drop it 1.75" its not much of a drop but its ruinin the slicks real fast
Posted: September 22nd, 2007, 1:42 am
your strut mounts up front you can turn them to get some adjustment. Thats what I did. I run ZX2 and intrax with the same drop, but I need camber plates in the rear not enough adjustment.
Re: Camber Kit
Posted: September 22nd, 2007, 4:20 pm
The Mx-3 does not use a camber kit. You can use different bolts to replace the upper bolt on the strut or you can turn the strut mount 180 deg. Have the car aligned zeroing out the toe in the front and rear, you should be fine.!vtec-this! wrote:where can i find a cheap adjustable camber kit for my mx-3? cause right now i am tearin the s--- out of my slicks and thats not to good.
Posted: September 25th, 2007, 11:30 pm
A good alignment shop should get it aligned within spec without the bolts.
Posted: September 26th, 2007, 9:42 am
no that is not possible by just under the car alignment. It will still have negative camber and you will still go through tires. More than likely you have to pay extra if they have to rotate the top strut mount to adjust the cambermx3autozam wrote:A good alignment shop should get it aligned within spec without the bolts.
Please just spend the $30 or so for the camber kit off of ebay. I bought the OBX one. You should recieve 4 bolts. They go in the top bolt spot that connects the strut to the spindle. I have this on both my mx-3's with intrax springs. You can install the camber bolts yourself and save yourself some cash at the alignment shop unless they will install the bolts for free...
I am glad I have an mx-3 and adjusting the camber is so easy! I've helped friends with hondas and those camber kits are so complicated!
Posted: September 26th, 2007, 3:55 pm
thanks thats the kind of info i was lookin forMooneggs wrote:no that is not possible by just under the car alignment. It will still have negative camber and you will still go through tires. More than likely you have to pay extra if they have to rotate the top strut mount to adjust the cambermx3autozam wrote:A good alignment shop should get it aligned within spec without the bolts.
Please just spend the $30 or so for the camber kit off of ebay. I bought the OBX one. You should recieve 4 bolts. They go in the top bolt spot that connects the strut to the spindle. I have this on both my mx-3's with intrax springs. You can install the camber bolts yourself and save yourself some cash at the alignment shop unless they will install the bolts for free...
I am glad I have an mx-3 and adjusting the camber is so easy! I've helped friends with hondas and those camber kits are so complicated!
Posted: September 27th, 2007, 11:18 am
