MX-3.com

At my High School we have a machine that can bend metal and cut.

I might make a custom exhaust for my MX3 for about $40 (just the piping, no muffler, straight with not cat)

But while I am add it I might also make a intercooler aswell. Maybe serveral.

In the future I would like to run a T3 setup
So does anyone know measurements for a intercooler that would fit our MX3s?

What should be the diameter for the piping inlet and outlet pipe aswell?
As a matter of fact, if someone can get me a diagram or something with measurements of turbo piping I can get on that aswell

you might want to put this thread in the forced induction area

Juans_93_MX3 wrote:At my High School we have a machine that can bend metal and cut.

I might make a custom exhaust for my MX3 for about $40 (just the piping, no muffler, straight with not cat)

But while I am add it I might also make a intercooler aswell. Maybe serveral.

In the future I would like to run a T3 setup
So does anyone know measurements for a intercooler that would fit our MX3s?

What should be the diameter for the piping inlet and outlet pipe aswell?
As a matter of fact, if someone can get me a diagram or something with measurements of turbo piping I can get on that aswell

use the one we had use in the group buy for the turbo kits, IIRC i tried to fit the biggest intercooler WITHOUR modding anything (bumper, rebar, etc.)

I'd run 2.25 in 2.5 out for the type of set-up you want.