Page 1 of 1
BP Injector Harness
Posted: September 5th, 2006, 8:20 pm
by 93_4Banger
The Injector Plug is an 8 pin and my 93 wiring harness is 6 pin what do i do?
Posted: September 5th, 2006, 10:24 pm
by Limegreen mx-3
get a bp harness
Posted: September 6th, 2006, 7:33 am
by 93_4Banger
I do have one sitting here but how would i go about hooking it up.
does the engine wiring harness just go straight to the ecu???
Posted: September 6th, 2006, 12:22 pm
by Typhoonk
the missing two wires are for the V.I.C.S. solenoid. Not needed to run, but will throw a code into the computer.
If you are using the B6 93 harness check out the faq. If not. Get a BP harness and enjoy the simplification.
Posted: September 8th, 2006, 1:08 am
by Domnknpimp
this is very easy, dont cut any wires. go to your old engine, and unplug the ingector harness, and plug that into your BP you will have to take off some of the tape to move one plug for the coolant temp you can wire the vics later