Page 1 of 1
How do you know its a KLZE ECU
Posted: October 26th, 2005, 7:08 pm
by mr_icez
First is the ecu the same for the mx-6 here then the one for the KLZE? If so how would i know if i am getting the ecu for the KLZE? If there is a link that allready talks about this can you give me it
thanks.
Posted: October 26th, 2005, 7:19 pm
by fieromx3
written by omaha95pgt a while back
I'll keep a log of ECU part numbers:
OBD-I:
PGT ECU's:
'93 MTX: KL07 (CA=KL07 18 881C)
'94 MTX: KL48, KL50 (CA),
'95 MTX: KL89, KL90 (CA) [dark gray connectors], I also found some evidence of early model '95's with ECU's labeled KL48-18881-C
'93 ATX: KL07
'94 ATX: KL48
MX-6 ECU's:
'93: KL01, KL03 (CA)
'94: KL57 (CA MX6) [bright yellow connectors], also KL55 18 881B (Federal)
'95: KL86, KL85 (no distinction between ATX and MTX, no consistency between A or B suffix)
KLZE ECU's (must be used in combination with JE50 VAF):
MTX=KL31
ATX=KL36
OBD-II
'96 ATX=KLD1
babybluemx3 had quoted omaha on this for someone else
Posted: October 26th, 2005, 8:08 pm
by mr_icez
thanks for that list but is one of those better to use with the KLZE or they all work the same.
Posted: October 26th, 2005, 8:16 pm
by fieromx3
it says right on it under kl-ze's ecu
kl-31 for mtx
kl-36 for atx
Posted: October 26th, 2005, 10:12 pm
by FIMotorMX-3
Both work well with the ze. I use the 36. It says it's for an automatic tranny but I have 5 spd and no problems with it. I also have a friend who has the kl31 ecu, but it's stamped with kl36 on the same sticker. I believe they are pretty much identical other than the tranny. I could be wrong and if anyone has more knowledge on the difference, please let us know. There are plenty of people using either setup.
Posted: April 19th, 2006, 6:33 pm
by Custom_V6_Limited_SE
Does the KL55 ECU work well with the KL-DE?