Just got an alignment after lowering
Posted: August 20th, 2005, 6:48 pm
I had a wicked toe in condition and it was blowing my treads off pretty quick.
I had already maxed out the front camber adjustment, which besides camber bolts there's not a whole lot you can do. Anyhow here's the final specs
CAMBER:
FL: -2.1
FR: -2.0
RL: -2.4
RR: -2.4
Toe and castor are all within spec.
This specs are still about a half degree off of factory spec, I don't think it's anything to worry about personally. Or should I look into camber bolts/plates?
I had already maxed out the front camber adjustment, which besides camber bolts there's not a whole lot you can do. Anyhow here's the final specs
CAMBER:
FL: -2.1
FR: -2.0
RL: -2.4
RR: -2.4
Toe and castor are all within spec.
This specs are still about a half degree off of factory spec, I don't think it's anything to worry about personally. Or should I look into camber bolts/plates?