MX-3.com

twice this week my clutch pedal got stuck to the floor.
fluid level is where it should be.

thoughts?

don't really know, but it happened on my mom's 626 a couple years ago...it eventually just went away and hasn't happened for a long time now. wierd....

Ck out pages H-4 (clutch troubleshooting), H-6 & H-7 (diagrams) of the online manual - link is on the MX-3.com homepage. Inspect the pedal assembly just underneath the pedal hinge/pivot point where there is a pushrod extending toward the firewall. Make sure the pushrod has free movement with no binding when pedal is depressed & released. On pg H-4 troubleshooting table, Mazda refers to it as the "pedal shaft" but the diagram label for the same part on H-7 appears to be "pushrod."

Ya or your clutch is f***ed right out. Hanging in on sympathy... Maybe you know more than your saying? You done nothing different? No point when it started?

The clutch is not old, not that that matters since i busted a fork 6 months after bpt install. But i had this one put in by 'pros'. My engine head seems to have shift, and my brake pads are a little low but that is all i think is wrong with the car right now. If this is just a fluke then great. O and i did replace master cylinder a couple yrs ago.

try bleeding it.