dashboard disassembly

misfitsfiend · Post by **misfitsfiend** » March 14th, 2005, 4:46 pm

i just want to know how would you take the plastic trim around the bezal and gauges on a 92 mx3 GS model

fry_81 · Post by **fry_81** » March 14th, 2005, 5:19 pm

2 screws in front/above the gauge cluster, and the rest pops out.

misfitsfiend · Post by **misfitsfiend** » March 14th, 2005, 5:22 pm

there were 3 on the inside top... but the thing still wont pop out

misfitsfiend · Post by **misfitsfiend** » March 14th, 2005, 6:09 pm

are there any like clips that are there... or should i just pull it out with force.. i just dont want to bust anything

spano · Post by **spano** » March 14th, 2005, 8:57 pm

i've noticed that a lot of pieces on the mx-3 don't have many screws holding them in (they have enough to hold it properly) but you would think there were more because of how strongly it's kept in place even after the screws are taken out. I'm always afraid to take things off because i don't want to brake the pieces.

fry_81 · Post by **fry_81** » March 14th, 2005, 9:45 pm

i took apart my dash(94 style) and i was a little cautious because i didnt want to break anything, but it will come, it just snaps into place.
im not sure if the 92-93 style has the little removable piece above the steering wheel or not? if it does remove it, i cant remember if theres a bolt in there or not.

sheridanmx3 · Post by **sheridanmx3** » March 18th, 2005, 5:19 pm

misfitsfiend wrote:there were 3 on the inside top... but the thing still wont pop out

ya there is 3 on the top then there is 2 right next to the steering wheel under the 2piece platic cover and it is tight getting off and back on i took mine out many times