Page 1 of 1
jackshaft for BP LSD tranny
Posted: February 20th, 2005, 9:07 pm
by valenzul
Anyone know where I can get a jackshaft for a LSD G25MR tranny.
It is larger than the ProLX ones
Posted: February 21st, 2005, 4:20 pm
by JWMotorsports
Are you using the new Mazdaspeed LSD? If so you'll need a custom jack shaft, Corksport is making them. You also need the driver side inner stub shaft from a MX-3 V6 to put on the Pro-LX driver side axle. I haven't done it yet, but my stub shaft is supposed to be on the way, I've had the LSD sitting in a box for months now!
Posted: February 21st, 2005, 8:43 pm
by valenzul
I just have a BP DOHC L tranny that I accidentally received when ordering a ProLx tranny. The driver's side Stubby I have and looks to be 28 splines and 1 1/8" thick.
It would be really good if I could use this tranny.
Posted: February 22nd, 2005, 6:07 am
by JWMotorsports
If nobody else can offer you help, call Derrick Ambrose @ Corksport and ask him what you need. If he doesn't know then good luck! Honestly I'm not sure by what you mean when you said it is an L tranny. I thought the only trannies were a DOCH G series, SOHC not sure series, and DOHC 4wd tranny (not sure what series either). Also....the trannies I'm talking about fall some where in the 90-early 94 Protege years. I'm using a 92 Pro-LX drive line and Shay is using one from I believe a early 90's Escort not sure which model (supposed to be same as Protege).