MX-3.com

Okay well i already ordered my motor and computer but my sponsor (HDS) has never done the swap i got a full intructional of the mx-3 links but what noone seems to mention is what clutch they used and if the tranny from kl8 fits also if anyone could please tell me where the call numbers on the ZE are that be great.
Mx-3 Kid (El Paso,Tx)

The k8 tranny fits. i used some perfomance clutch i got off ebay..worked fine
You can also use an mx6, probe gt, or 626 manual tranny.(v6 of course)

im not sure what u mean by call numbers, but the codes and shiz are on the back of the valve covers (dont need to remove anything to see them..maybe some dirt) and the have codes stamped on the cams. forget what there suppose to say : P.

woah woah are yo0u in el paso? email me! also in el paso..
hgallegos915@msn.com

What i meant by what clutch to use was off of the 1.8 or the 2.5 is there a difference

-------
MX-3 KID Of El Paso Tx

the 1.8L clutch is 10mm smaller thanl the 2.5L clutch, the 2.5L clutch will fit on the K8 flywheel

so any clutch kit from a 2.5 (mx6-probe) will fit into the stock mx3 tranny housing. so what would be better, getting a aftermarket clutch for the mx3 or the same clutch for the 6 or probe?

YES! the clutch interchanges with the 626, probe, mx3, mx6..all this info is in the FAQ.

If you want a slightly bigger clutch, get the probe one. Its up to you. my mx3 ACT is plenty for my setup.

I hope you dont have a automatic though
A ATX from the 1.8L cant handle all the torque

Don't skimp on the clutch, you might want to up the power down the road(cams,N2o). Be sure to inspect the mounts, poly fill if necessary might wanna go mazdaspeed. These are some of the things I'm going through now with cams and all.

Thanks 4 all the help i already ordered a 6 puck clutch for the mx-6 thanks

Mx3 Kid (El Paso, Tx)

Read the Faq, all this info is in there.