ricer anthem
- papa roached
- Senior Member
- Posts: 2761
- Joined: December 10th, 2002, 2:01 am
- Location: Montgomery, WVa
ricer anthem
93 MX-3 GS (collecting parts for Eunos Presso conversion), 94 626 Transmission (4.10 gears), KL31 camed KL-ZE, Millenia intake, Millenia TB, SSAutochrome V2 headers, Magnaflow cat, 2 1/4 in pipe, Top Speed Pro 1 muffler, 9lb Fidanza Flywheel, ACT clutch, Corksport SS clutch line, Corksport SS brake lines, Unorthadox UDP, 255 lph fuel pump, HEI mod, ghetto-charger intake, KL36 ECU, SRD transverse crossmember bushings, SRD shifter extention bushing, SRD crossmember, Corksport bronzoil shifter bushings, Brembo Crossdrilled and Slotted rotors, 15 inch Konig Heliums, ZX-2 S/R struts, Eibach lowering springs, OEM front strut bar, Ebay rear strut bar, BFGoodrich G-Force T/A KDWs
Parts needing installed: turbo kit from BB (if i ever get it), 9.0:1 CR Diamond pistons, 4340 forged H beam rods, C/J-Spec spoiler, Nissan red tops in KL rails
http://www.cardomain.com/id/blazejeremy
Parts needing installed: turbo kit from BB (if i ever get it), 9.0:1 CR Diamond pistons, 4340 forged H beam rods, C/J-Spec spoiler, Nissan red tops in KL rails
http://www.cardomain.com/id/blazejeremy
Re: ricer anthem
wtf
Re: ricer anthem
That's OFFICIALY the GAYEST thing I have EVER seen in My Entire 18 years on Earth.....That's the kinda stuff that makes me Dislike HONDA....Cause they Do all that DUMB $h!t ALL THE TIME
Ferrari Red w/silver Metallic 92' Mx-3 GsR: Blown 5 Built motors from my past project and am going to N/A for a while as I get use to Megasquirt for proper tuning then may boost....TT setups have too much lag and too low of a power output for the rpm range i sought....Single is better and may do that in future...New project is custom Alum Mani/ with 3-4" runners...NO ?'s about my previous setup I don't want anyone to waste as Much $$$$$$ as I did...listen to BabyBlue and the those guys and go with thier F/I setups
- fry_81
- Regular Member
- Posts: 1898
- Joined: April 22nd, 2004, 2:01 am
- Location: Barrie, Ontario, Canada
- Contact:
Re: ricer anthem
1994 5spd GS Parts Car For Sale 800obo. e-mail for details. fry_81@hotmail.com
- monstar-mx-3
- Regular Member
- Posts: 1112
- Joined: February 28th, 2002, 2:01 am
- Location: vancouver
Re: ricer anthem
Holy Sh*t! I'm impressed ..it sounds pretty good.
Re: ricer anthem
LOL i love it, i showed it to my friend who put a V-tec in his 89 CRX and he got all mad LOL anyone know how to put that on a CD ? and i am not kiddin
<small>[ September 01, 2004, 11:47 PM: Message edited by: m92_MX3 ]</small>
<small>[ September 01, 2004, 11:47 PM: Message edited by: m92_MX3 ]</small>
CTC Racing
92 1.6L
93 323 Tranny, ACT clutch, Exhaust, cold air intake, MSD Blaster 2 coil, MSD 8.5mm super conductor wires NGK V-power platinum plugs,engine dress up,custom interior(almost done), GS front bumper, GS 5 spoke wheels Painted white.
92 1.6L
93 323 Tranny, ACT clutch, Exhaust, cold air intake, MSD Blaster 2 coil, MSD 8.5mm super conductor wires NGK V-power platinum plugs,engine dress up,custom interior(almost done), GS front bumper, GS 5 spoke wheels Painted white.
- papa roached
- Senior Member
- Posts: 2761
- Joined: December 10th, 2002, 2:01 am
- Location: Montgomery, WVa
Re: ricer anthem
http://www.angelfire.com/tn3/kaitlyn/vtec1.mp3 right click and save as
93 MX-3 GS (collecting parts for Eunos Presso conversion), 94 626 Transmission (4.10 gears), KL31 camed KL-ZE, Millenia intake, Millenia TB, SSAutochrome V2 headers, Magnaflow cat, 2 1/4 in pipe, Top Speed Pro 1 muffler, 9lb Fidanza Flywheel, ACT clutch, Corksport SS clutch line, Corksport SS brake lines, Unorthadox UDP, 255 lph fuel pump, HEI mod, ghetto-charger intake, KL36 ECU, SRD transverse crossmember bushings, SRD shifter extention bushing, SRD crossmember, Corksport bronzoil shifter bushings, Brembo Crossdrilled and Slotted rotors, 15 inch Konig Heliums, ZX-2 S/R struts, Eibach lowering springs, OEM front strut bar, Ebay rear strut bar, BFGoodrich G-Force T/A KDWs
Parts needing installed: turbo kit from BB (if i ever get it), 9.0:1 CR Diamond pistons, 4340 forged H beam rods, C/J-Spec spoiler, Nissan red tops in KL rails
http://www.cardomain.com/id/blazejeremy
Parts needing installed: turbo kit from BB (if i ever get it), 9.0:1 CR Diamond pistons, 4340 forged H beam rods, C/J-Spec spoiler, Nissan red tops in KL rails
http://www.cardomain.com/id/blazejeremy
- justintoxicated
- Regular Member
- Posts: 90
- Joined: May 28th, 2004, 2:01 am
- Location: glassboro, nj
Re: ricer anthem
d00d - i think the song is just a joke, a funny one at that...That's OFFICIALY the GAYEST thing I have EVER seen in My Entire 18 years on Earth.....That's the kinda stuff that makes me Dislike HONDA....Cause they Do all that DUMB $h!t ALL THE TIME
Got Rice? You do!
- exdream_mx3
- Regular Member
- Posts: 327
- Joined: April 19th, 2003, 2:01 am
- Location: Hanover, PA
- Contact:
-
- Regular Member
- Posts: 260
- Joined: November 25th, 2003, 2:01 am
- Location: Brockville, Ontario, Canada
Re: ricer anthem
Describes all the civic and domestic rice cars (neons, cavis) around here pretty good.
- Franko
- Supporting Member
- Posts: 1443
- Joined: September 2nd, 2002, 2:01 am
- Location: Newfoundland, Canada
- Contact:
Re: ricer anthem
Anyone notice that he has 141 thousand hits on that page? Holy crap.
93 MX3, BP, Haltech E6X, Bully Six Puck Clutch, Pauter Rods, Wiseco Pistons, Port and Polish, Turbonetics T3/T4 Ball Bearing turbo and a partridge in a pear tree.
Re: ricer anthem
hey thats cool u know any more songs like that??