VolfenHags?
Posted: July 4th, 2003, 8:55 pm
so i just bought 2 10" volfenhags anyone know how these speakers handle? they sound awsome but just wondering if anyone had any experience with them <p>here are the specs:<p>ZX 4710DVX Specifications: <p>
Magnet: 160 oz. Double stacked Ferrite magnets
Frame: 5 spoke Die-cast aluminum basket
Cone: Reinforced aluminum curvilinear
Surround: Oversized buytl rubber
Spider: 2 Flat ultra excursion
Power handling: 400 watts RMS, 800 Watts Program (conservative)
T Yoke: Industrial Chromed Hex bolt retained, Bumped and Vented
Double damper magnetic motor assembly
Cooling: Double Vented (T Yoke and Motor Side vents)
Voice Coils: 4 Layer Dual 4 Ohm High Temperature black Aluminum
Voice Coil Diameter: 2.2"
Nominal impedance: 4 ohms / per coil
DC resistance (Re): 3.2 ohms each coil
Frequency range: 20 Hz-1.1 kHz
Fs:32 Hz
QTS:.461
QES:.541
QMS:7.62
VAS:35L
SD:.0346M
SPL:89 dB 1W/1m
Xmax:16mm
Mounting Depth: 145 MM
Mounting Hole Dia.:246 MM
Net weight: 21lbs
Magnet: 160 oz. Double stacked Ferrite magnets
Frame: 5 spoke Die-cast aluminum basket
Cone: Reinforced aluminum curvilinear
Surround: Oversized buytl rubber
Spider: 2 Flat ultra excursion
Power handling: 400 watts RMS, 800 Watts Program (conservative)
T Yoke: Industrial Chromed Hex bolt retained, Bumped and Vented
Double damper magnetic motor assembly
Cooling: Double Vented (T Yoke and Motor Side vents)
Voice Coils: 4 Layer Dual 4 Ohm High Temperature black Aluminum
Voice Coil Diameter: 2.2"
Nominal impedance: 4 ohms / per coil
DC resistance (Re): 3.2 ohms each coil
Frequency range: 20 Hz-1.1 kHz
Fs:32 Hz
QTS:.461
QES:.541
QMS:7.62
VAS:35L
SD:.0346M
SPL:89 dB 1W/1m
Xmax:16mm
Mounting Depth: 145 MM
Mounting Hole Dia.:246 MM
Net weight: 21lbs