Page 1 of 1
NEED THIS DONE TONIGHT
Posted: March 30th, 2003, 7:16 pm
by Mx-3 Xplod
my wheel bearings are shot and i got everything off and i can see the wheel bearing how do i get the bearing housing out?? please help i gotta get this done tonight.
Re: NEED THIS DONE TONIGHT
Posted: March 31st, 2003, 9:53 pm
by ryanlindenberg
punch and hammer. be sure not to scratch the inside of the hub
Re: NEED THIS DONE TONIGHT
Posted: April 1st, 2003, 4:45 pm
by jaydog5678
press.
Re: NEED THIS DONE TONIGHT
Posted: April 1st, 2003, 7:34 pm
by atila
Good luck doing it at home. The bearing his in the center of the spindle and there's the cage that will be on the hub. to remove the bearing from the spindle you need a press and to remove the cage from the bearing you need a set of torch. you heat the cage until it's red then you put it into water and it should fall off.