MX-3.com

amazing job on the outlet, but i still think you should clearance the lower rad support.

I absolutly love this car with a passion truly one of my favorite MX-3's on this site...

where did u get that piller with the pod?

youdirtyfox wrote:Will that not contact during engine movement?

if will , i can take off some of material

BTW
i relocated power steering cooler (will be intercooler instead) and fit much bigger cooler from mazda 626

custom made water cooler (two times wider and 10cm less than stockk)


Intercooler on board


i want keep sleeper style

mooore coolers

lol your power steering fluid gets that hot. I want to do the same but use it as an oil cooler. You said you got it from a 626? Or is it an aftermarket thing. did you cut the chassis any or it all fit behind the bumper just fine? Does look good BTW

no i dont want to cut chassie - only bumper was cut. Power steering cooler is OEM Mazda from 626 but i dont remeber witch one. Of course this power steering cooler is little exaggerated but why not

any updates on this man?

unfortunately, the engine was broke One night two ZE retainer cracked and when my friend started to fix it I saw little marks on bearings causes of lack oil...So i now finish rebuild engine with KLDE valves/retainer (much stronger than ZE) and with reconfigurated oil relocation kit. I hope it will help, i lost this season

Love the supercharger...ill be doing the same but I have an M90 from the Ford Superbird. Havnt done the math yet. But im all about the budget. Ill figure out what ratio to get what psi I want then find some cam gears at the yard the size I need. Instant cog drive. No chamce of slipping.

M90 is pretty big...

M90 only in battery place

Even then, just for it's capacity, it's for a larger motor, 3.0 to 5.0L. My truck is a 3.3 with an M62

Car back on street

I have intaled KLDE retainers and springs.


Spring Set:)
- new gear selector
- OEM rubbers and screws for gear selector
- 10W60 Oil + OEM filter
- poli on the back
- SACHS cover for struds


Rear Tokico HP struds.

I thing i dont send this photo...Air filter for Supercharger

YESSSS!!!!!!!! very cool i love its back on the road. What intake is that? I want to use a straight neck as well but im not 100% sure I want to relocated the battery just yet....

would love to see some pics of the supercharger set up here how everythings installed