Posted: July 18th, 2007, 9:03 pm
Damn ProbeTalk randomness...thanks for the info!n2ogsze wrote:It's going on right now so you had better get in on it.
MX-3.com
The Worlds First and Largest Mazda MX-3 Forums
https://mx-3.com/phpbb3/
Hector's turbo thread
Page 2 of 2
Posted: July 21st, 2007, 8:37 pm
ok already placed order, all i want and need from the megasquirt is for the ecu not to auto tune the timing, it says i need to tune it manually, perfect to retard the timing 
alrfeady saving up for the wideband.. it seems im starting to go the right route. Im thinking of another turbo blower..
overtime at work is killing me! lol
alrfeady saving up for the wideband.. it seems im starting to go the right route. Im thinking of another turbo blower..overtime at work is killing me! lol
Posted: July 21st, 2007, 9:35 pm
finailly someone at least going the right route. :D
Posted: July 25th, 2007, 9:17 pm
My payment was sent, WOAH he also sold me the harness for only 40 dllrs, color coded and labeled. Should be an EASY install.
On another note, got a guy to trade me a cosmo afpr for my kl 31 cams.
On another note, got a guy to trade me a cosmo afpr for my kl 31 cams.
Posted: July 28th, 2007, 9:23 pm
Hey I got this.
http://cgi.ebay.com/ebaymotors/BILLET-O ... enameZWDVW
Can I use any line from like lets say home depot? or any special fitting that I may need?
http://cgi.ebay.com/ebaymotors/BILLET-O ... enameZWDVW
Can I use any line from like lets say home depot? or any special fitting that I may need?
Posted: August 14th, 2007, 3:18 am
Ok guys .. i noticed I dont use my mx3 AT ALL.. so yes.. the time for turbo has arrived!! I already got the oil fitting i needed for the turbo. Will be getting boost gauge. still sourcing out a wideband gauge.
This coming week.. possibly even wednesday ill start. Ill take out the engine half ways to fit the manifolds in , give it a few welds here and there and start bolting it up. Ill elt ya guys know how it went.
This coming week.. possibly even wednesday ill start. Ill take out the engine half ways to fit the manifolds in , give it a few welds here and there and start bolting it up. Ill elt ya guys know how it went.