K8 Engine Parting Out

[Sam Baker]

well i swapped the ze in, and now my k8 sits.. so if anybody needs parts (158,XXX miles on engine), i can take em off and sell for cheap. thanx :p
~ sam

*i also have a straight-neck manifold for you probe/mx6 owners, or you die-hard mx3 power freaks

<small>[ August 09, 2004, 08:45 PM: Message edited by: Sam Baker ]</small>

[Bouncer]

Hey how much for your engine and what year is it for

[Sam Baker]

car is a 1993 GS. the engine ran awesomely up until the swap a few weeks ago. i recently had new valve cover gaskets installed, along with a valve adjust. there are a few parts i used on the ze like the a/c compressor, distributer, etc etc but you know... i'm open for any offers. just lookin to sell it so lemme know if u want pix of info, thanks

[jimishadow]

are you sure you had a valve adjustment,as far as i know they are hydrolic,co you have the lower belt tensioner?how much shipped to 18332 if you have it.thanx

<small>[ July 24, 2004, 08:13 AM: Message edited by: jimishadow ]</small>

[msbmx3]

do you have a starter? if so how much?

[2fazed]

Might be interested in a few weeks if things go right. Did you put your engine in, or had it done?

[Sam Baker]

will check in a few min on those parts.. and 2fazed i had it put in by stang67fb in Sac, the other ze owner. anywayz brb

[Sam Baker]

ok i assume the tensioner is under that cover on the side right? i dont feel like taking it off, but i'm guessin that i DO have it. the starter.. sorry could u tell me where to find it? lol i'm so lame.. i'd rather sell the engine as a whole, but if there are people who need parts then i'll part it. anywayz here is a pic of it:


thanx

[Sam Baker]

btw 2fazed, i know a place that will swap engines in for $600 up here.. so if u want a really cheap k8, send me a PM later

[jimishadow]

its not under the cover,its in the bottom pic,the lower left pulley you adjust the belt with the power steering pump wae above it.how muchshipped to 18332?thanx

[Sam Baker]

i duno.. make me an offer
send me a PM or somethin and we'll work it out.. shipping wont be much cuz i work for fedex

[Sam Baker]

anybody interested in a slightly used engine? lol

[Sam Baker]

BUMP anyone need parts off a K8???

[BADMX3]

i've asked other people i need all the pulleys, and the protectors for belts and also the tensioner. how much you want for them?

thanks bro!

[Sam Baker]

ehh i duno how much they're worth haha.. so you want all the belt pulley's, tensioners, and the cover? all that stuff in pic #2 eh? um i can give it to u for $40 shipped. lemme know what u think.. anybody else need stuff? PM me with interests, thanks