computer swap

Ryan · Post by **Ryan** » September 15th, 2011, 10:34 pm

Looks like this:

ftawizard · Post by **ftawizard** » September 15th, 2011, 10:38 pm

No ......

ftawizard · Post by **ftawizard** » September 15th, 2011, 10:40 pm

I have never taken the cover off it's a black place and says diagnostic on it it's behind the battery

Ryan · Post by **Ryan** » September 15th, 2011, 10:42 pm

Yes, I know what that is, I'm asking you if you have this port in the cabin. It is the OBDII scantool interface. It must be within 2' of the driver, its located in the driver footwell.

Do you have it or not?

ftawizard · Post by **ftawizard** » September 15th, 2011, 10:52 pm

No I don't believe I do have it

ftawizard · Post by **ftawizard** » September 30th, 2011, 1:42 am

Ok I swapped ecu and harness back to original ..... Haveing a idle up and down issue and still no where to plug in the yellow four prong plug (smaller of the two plugs coming off fuel rail wire harness) .... As well as my harness only has one plug for a o2 sensor.....

One other thing can someone post a pic of where a egr position sensor is suppose to mount? Again it's a 95 mx3 4 cylinder 1.6 dohc please and thank you

gxser · Post by **gxser** » October 11th, 2011, 1:15 am

i would take that harness and the B6DE from the 96 you have ive been looking for one all summer!!!!

ftawizard · Post by **ftawizard** » October 11th, 2011, 9:34 am

Where abouts are u located I got the ecu and the harness

MX-3.com

computer swap

Re: computer swap

Re: computer swap

Re: computer swap

Re: computer swap

Re: computer swap

Re: computer swap

Re: computer swap

Re: computer swap